bing tracking image
Q & A Icon

Does Coleman-Mach WiFi Thermostat Support Heat Pump and Propane Furnace Backup  

Updated 11/11/2026 | Published 11/10/2026

Question:

Does the Coleman Mach wifi thermostat handle two heat sources, for example a heat pump as the primary and propane furnace as the secondary heat source?

0

Expert Reply:

Hey Chad! Yes, the Coleman-Mach WiFi Thermostat # CM46MR supports both a heat pump and propane furnace with a compatible control system. It even has a dual-fuel balance point setting that automatically switches between the two based on the outdoor temperature.

When the outdoor temperature is 2 degrees above your set balance point, the heat pump is used. When it drops 2 degrees below that point, the propane furnace takes over. See the attached photo.

What kind of setup do you have now?

expert reply by:
0
Robin H
CM46MR
CM46MR
(click to enlarge)
CM46MR
CM46MR
(click to enlarge)
Chad S. profile picture

Chad S.

11/11/2026

Hello, Robin. Thanks for the reply. My current setup uses the heat pump as the primary heat source unless the room temperature is 3 degrees or more lower than the set point. If that's the case, it leaves the heat pump running and then starts up the propane furnace as a secondary heat source. Does this sound possible with the Coleman-Mach WiFi Thermostat? I like using electricity over propane for heat. Thanks. Chad

Robin H. profile picture
Etrailer Expert

Robin H.

11/11/2026

@ChadS the # CM46MR uses the outdoor temperature and your selected balance point to switch between the heat pump and propane furnace. As far as I know it doesn't support running both simultaneously when the room temperature falls below your set point, so it wouldn't operate the same way as your current thermostat.

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>