Moving Trailer Axle from Below Leaf Springs to Above the Leaf Springs
Updated 08/01/2014 | Published 07/31/2014
Question:
Im trying to lower my trailer by placing the axles above the springs rather than below the springs as the are now. When fully loaded there appears to be more than enough space above the springs to accommodate the axle above them. Am I correct to believe I can use an over / under kit to make this change? Thanks.
asked by: Doug W
Expert Reply:
Yes, you can use the over/under conversion kit # K71-385-00 to move the axles to the tops of the leaf spring stacks.
Dexter has the following note on the conversion kits:
When converting from underslung to overslung, the installation of bump stops to prevent suspension over travel and resulting possible spring damage or breakage is highly recommended. Axle travel should be limited to the amount available prior to mounting conversion.
When converting from overslung to underslung, adequate suspension travel is required to prevent the axle(s) from bottoming out prematurely, resulting in axle bending.
Product Page this Question was Asked From
Dexter Trailer Springs Over-Under Conversion Kit
- Trailer Suspension Parts
- Alignment and Lift Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Round Axle - 3 Inch
- Dexter
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: trailer suspension parts
- Video: Review of Tie Down Trailer Fenders - No Step - TD75VR
- Shop: Dexter Trailer Springs Over-Under Conversion Kit
- Shop: Tie Down Adjustable Teardrop Fender for Tandem Trailers - 9" Wide x 16" Tall
- Search Results: trailer fenders
- Search Results: boat trailer fenders
- Search Results: fender mounting bracket
- Shop: Dexter Trailer Springs Over-Under Conversion Kit
- Search Results: trailer leaf springs
- Search Results: 12 volt toggle switch
- Search Results: 2000lb axle
- Shop: Trailer Axle with Idler Hubs - 4 on 4 Bolt Pattern - 72" Long - 2,000 lbs
- Q&A: How to Flip a 1-3/4" Diameter Axle So the Springs are Above the Axle
- Shop: 3-Leaf Double-Eye Spring for 2,000-lb Trailer Axles - 23-1/2" Long
- Shop: Tandem Axle Trailer Fenders - Rounded Edges - Steel - 14" to 15" Wheels - Qty 2
- Shop: Trailer Axle with Idler Hubs - 5 on 4-1/2 Bolt Pattern - 60" Long - 2,000 lbs
- Q&A: What Fenders will Work on My Nitro Boat Trailer with 14" Wheels that are 66" Long?
- Video: Breaking Down the Tandem Axle Trailer Fenders
- Q&A: Will Triple Axle Hanger Kit # APTT5 Work with Leaf Springs E64SR
- Video: Feature Breakdown: Triple-Axle Trailer Hanger Kit for Double-Eye Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Shop: Base Plate for Tow Bar
- Video: What to Know About the Front/Center/Rear Hanger for Double-Eye Springs
- Video: Complete Breakdown of the Dexter Trailer Springs Over-Under Conversion Kit
- Video: Hands-On with the Dexter Trailer Springs Over-Under Conversion Kit
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
on Trailer Suspension Parts
