bing tracking image
Q & A Icon

MaxxFan 4700N Lift Not Functioning  

Updated 09/18/2026 | Published 08/20/2026

Question:

I have a Maxxfan 4700N that needed a new lift motor. I purchased a motor from you and the motor will run but will not lift the lid. I assumed it must also need the lift mechanism so I also installed a new mechanism. It still will not lift the lid, the motor acts/sounds like it does not have enough power to lift the lid. I have looked for anything binding and everything seems to be good. Beginning to wonder if I got a bad motor. Thoughts?

0

Expert Reply:

Thanks for letting us help Marty. Normally, I'd cross reference the parts you ordered for your MaxxFan 4700N, but I'm not able to locate any orders under the email address you used to submit this question. It's certainly possible that you received a defective motor, but before assuming that's the issue, I'd first like to make sure you have the correct replacement parts.

The correct replacement lift motor for your MaxxFan 4700 series is the Replacement Lift Motor for MaxxFan Plus # MA10-20270. Another component worth checking is the operator mechanism, which is the gearbox located between the lift motor and the lid lift arms. Over time, the internal gears can become worn or stripped, causing the lid to stop opening or closing properly even when the motor is functioning. The correct replacement operator mechanism for your MaxxFan 4700N is # MA10-20281K-1AF.

Are these the parts you ordered? Please reply with this and any other parts you have already replaced.

expert reply by:
0
Christopher H
Marty W. profile picture

Marty W.

9/18/2026

Hi Christopher, that is the part number I purchased. It was on order #125249031. However, my problem does not appear to be the motor as I purchased a second motor from another vendor and have the same results. I have also replaced the gearbox. When I hand crank the knob it goes up and down without any problem. I have measured the voltage and there is 11.5 volts going to the motor. Thanks for your help. Marty Worline

Christopher H. profile picture
Etrailer Expert

Christopher H.

9/18/2026

@MartyW Have you tested the voltage output from the motor while attempting to open the vent? If you do this and see voltage drop there's resistance somewhere. Likely from a bad connection or failing circuit board. The # MA32WV is the replacement control board for the N series vents but at this price you're pretty quickly approaching the cost of replacing the vent.

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>