How Thick is the Caliber ProTech XT Flooring CA89AJ?
Updated 03/04/2026 | Published 02/03/2026
Products Featured in This Question
Question:
Caliber ProTech XT Flooring for Trailer or Garage - Black - 27 Sq Ft Part Number: CA89AJ how thick is this flooring, and what is the best way to cut it?
asked by: Thomas D
Expert Reply:
Hey Thomas, welcome back. The Caliber ProTech XT Flooring item # CA89AJ is 1/2" thick. The manufacturer says in the instructions you can use a knife or a saw. I have something similar in my shop and I used a table saw to cut mine. The only issue I ran into was the plastic that comes off while you're cutting builds up a bit.
Do you plan on using this flooring in a trailer, garage, shop?
(click to enlarge)
Product Page this Question was Asked From
Caliber ProTech XT Flooring for Trailer or Garage - Black - 27 Sq Ft
- Trailer Flooring
- 18L x 9W Inch
- Enclosed Trailer
- Garage and Workshop
- Toy Hauler
- Plastic
- 27 Square Feet
- Black
- Caliber
more information >
Continue Researching
- Q&A: How to Tighten Fastway Ball Mount Hitch Balls
- Q&A: Should I Replace The ST145/R12 Trailer Tires Before Taking a 1,000 Mile Trip
- Q&A: How to Make 2x6 Carpeted Bunk Boards for a Boat Trailer
- Q&A: Trailer Cover for a 6' x 12' Enclosed V-Nose Trailer
- Q&A: Would Enclosed Trailer Ramp Spring # CB250D96SHD Be Rated High Enough for 92 x 74 inch Ramp
- Q&A: Recommended Garage Door Spring for a 7' Wide Enclosed Trailer
- Q&A: How Much of Each Gauge of Wire Fit Inside a Wire Loom Comfortably
- Article: Trailer Lighting Requirements
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Electric Trailer Brakes: How They Work & What to Buy
- Article: How to Install E-Track in 3 Easy Steps
- Article: Determining Trailer Tongue Weight
- Article: Trailer Wiring Diagrams
Jerred H.
3/4/2026
Hey Thomas, how did cutting the ProTech XT flooring go for your project? Did the knife or saw method work better for you? Your experience could help others deciding how to trim their panels cleanly.