Availability of E/X Track Basket Mounting Brackets Without Basket

Question

Question:

Can I buy the basket mounting brackets separately?

asked by: Chris M

0

Expert Reply:

Hi Chris, I'm sorry to say the brackets are not available separately. The only option is to get them with the CargoSmart Wire Basket for E Track and X Track # 3481718 or # 3481719.

Are you wanting to use these for another basket or something else?

expert reply by: Robin H

0

CargoSmart Wire Basket
(click to enlarge)

Robin H.

3/4/2026

Hey Chris, did you end up getting one of the CargoSmart wire baskets to get the brackets you needed? Knowing what you decided could help others looking for the same parts.

Answer 1

E-track can be driven over and it will be fine. It would not collapse or otherwise damage itself. You could use and drive over the Erickson Horizontal E-Track #EM19147. Then for a wheel strap the Erickson E-Track Wheel Tie-Down Strap with Roller…

view full answer...

Answer 2

Since the slot dimensions and capacity of different brands of E-Track are identical, really the only differences are the finish and the lengths the tracks are sold in. If you're using the E-Track in an area where aesthetics are important, you can…

view full answer...

Answer 3

Hey Brian, we have a replacement inner member for the TDE LP8500 you have with the part #DX97UR. This replaces the inner portion of the actuator and allows you to leave the outer part attached so you don't have to do any welding.

view full answer...

Answer 4

I do have an option for you but in order to switch an actuator from disc to drum brakes you'd need a new master cylinder. Unfortunately, we don't have any replacement parts for the Tie Down Engineering LP8500 as it's discontinued.…

view full answer...

Answer 5

There is a way to charge the battery on your trailer with your vehicle. This is done by using the Redarc In-Vehicle BCDC Battery Charger #331-BCDC1225D. This can be attached to the alternator on your vehicle and if you have the proper gauge wire,…

view full answer...

Answer 6

I'd go with the part #UF21-001091. It locks the tire of each axle so well to each other that the trailer would not roll at all if pushed while you were hitching up. I attached a review video for more info. If you wanted to be super cautious a…

view full answer...

Answer 7

According to my research the CellTech trailers looked to have vertical etrack installed directly to the walls, but since you're trailer has the honeycomb paneling that isn't solid all the way through you'll need to install some studs to…

view full answer...

Answer 8

The TDE 46245 you have is a Hub and Rotor for a 3500lb axle and uses inner bearing #L68149 and outer bearing #L44649 and uses the 5 on 4-1/2" bolt pattern For a replacement idler hub you can use the Trailer Idler Hub Assembly for 3,500-lb E-Z…

view full answer...

Answer 9

The Trailer Hub & Drum Assembly #8-388-80UC3 you were looking at is designed specifically for 42mm Dexter Nev-R-Lube axles and you do not grease any of the components. This hub has sealed bearing cartridges which do not get greased. Now if you…

view full answer...

Availability of E/X Track Basket Mounting Brackets Without Basket

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching