Wiring Diagram for the RVS RV Backup Cameras

Updated 09/03/2024 | Published 01/10/2024

Question:

So I install these systems on FedEx trucks well a guy asked me to fix a couple11 of them he had installed by another guy which I offered but he didn’t like my price so now I have had to fix everyone one of them there is one that in the back guy didn’t zip tie it well and door cut rear cameras cable then they cut other side and tried to wired it together and he doesn’t have any extra parts is there any way to rewire to and get it to work

asked by: Chad S

Expert Reply:

There may be a way to get the Rear View Safety Backup Camera System # RVS-062710 to work if you have enough wire.

To wire these cameras properly you're going to need to connect the red to power, the yellow to the left turn signal, the brown to the right turn signal, the blue to the back/rear, and the black to a ground.

I'll go ahead and attach a wiring diagram as well for you to check out.

expert reply by: Bryce D

Wiring Diagram
(click to enlarge)

Stan P.

8/30/2024

Hi Bryce I have this system but wired a bit different, what do think and any issues, I have the power loom on the A frame of caravan which connects to each of the 4 cameras and picks up the power and negative from the anderson plug. Also wired to positive is the yellow trip wire.Then I have an extended 18pin monitor cable connected to the screen(on the dash) that runs to the back of my vehicle. When I hitch up my caravan I connect the 18pin monitor cable on the back of my vehicle and the 18 pin monitor cable on the front of my A frame. Do you see any issues with power?? Supply?.

Bryce D.

9/3/2024

@StanP Stan, I don't really see any issue with the way you're powering this system. I'd just double check that you are in fact getting 12V of power. As long as you're getting 12V it doesn't matter what you do or how it's hooked up.