Will Draw-Tite Front Mount Hitch Fit 2023 GMC Sierra 1500 AT4
Updated 12/29/2025 | Published 12/11/2025
Question:
Im looking at the draw-tite DT44HR. Im wondering if it fits a 2023 gmc 1500 at4?
asked by: Tim
Expert Reply:
Hi Tim; yes, the Draw-Tite Front Mount Trailer Hitch Receiver # DT44HR will fit your 2023 GMC Sierra 1500 AT4. We had another customer successfully install this on their 2025 AT4, which you can see in the attached picture. They did add the following in their review which you might find helpful for installation:
"Just finished installing this on a 2025 GMC Sierra 1500 AT4. I was worried about how high or low it would sit, but I was very pleased with how it turned out, especially since the website flags this model as not fitting my truck. It is tucked up underneath as high as practically possible without requiring trimming to the areas around the receiver tube. The only trimming needed was to small portions of the two main tabs that secure the air dam to the vehicle. The fit was perfect and it lined right up with attachment points. You do not need to remove the air dam to install. Just unscrew the two screws on each tab from underneath and also unscrew several of the smaller 7mm screws on both corners. Access to these is behind the wheel well lining. This allows the air dam to flex enough to get in behind it. The most challenging part of the install didn’t have anything to do with the product but it was trying to remove the bolt holding the driver side tow hook (this bolt gets replaced to serve as an attachment point). It was stuck in there pretty good and was in too tight of a space to hammer out with a punch. I ended up unscrewing the fog light which allowed for a long steel rod to hammer out this bolt. Other than that, the install was pretty straightforward."
What will you be using the hitch for?
(click to enlarge)
Continue Researching
- Q&A: Will Draw-Tite Front Hitch Fit 2026 GMC Sierra 1500 AT4
- Shop: Front Mount Hitch
- Shop: Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Search Results: gs 2125dl seal
- Search Results: spring perch
- Q&A: What Front Mount Hitch Fits The 2024 GMC Sierra 1500 AT4
- Shop: Gooseneck Hitch
- Shop: Trailer Hitch
- Shop: Optronics Thinline LED Trailer Clearance or Side Marker Light - Submersible - 4 Diodes - Red Lens
- Shop: Spring Seat for Typical 3,500-lb, 2" Square Trailer Axles - Galvanized Steel
- Shop: Optronics Mini Side Marker and Clearance Light - Submersible - 3 Diodes - Clear Lens w/ Red LEDs
- Search Results: stake pockets tie down anchors
- Search Results: stake pockets trailer tie down anchors
- Shop: B&W Ball and Safety Chain Kit for Ford, GM, Chevy, and Nissan Titan XD Underbed Gooseneck Hitch
- Shop: Gen-Y 2-Tang Clevis for 2" Hitch Receivers - 16,000 lbs
- Shop: Flint Hill Goods 2-Tang Clevis for 2" Hitch - 1" Hole - 5K
- Search Results: 3500 lb axle bearing kit
- Search Results: trailer door latch
- Search Results: breakaway switch
- Q&A: Choosing the Correct Replacement Spring for an Enclosed Trailer Ramp Door
- Shop: Fifth Wheel Hitch
- Shop: Vehicle Snow Plows
- Q&A: Recommended Snow Plow and Front Hitch for a 2024 Chevy Silverado
- Q&A: Does the Curt Front Hitch C22NR Require Trimming When Installed on a 2024 GMC Sierra 1500 AT4?
- Q&A: Does Draw-Tite Front Hitch Fit 2024 GMC Sierra 1500 AT4
- Q&A: Availablity Of Replacement Ramp Door Spring For 94 Door That Weighs 140lbs
Robin H.
12/29/2025
Hey Tim, how did the Draw-Tite front hitch work out on your Sierra 1500 AT4? It sounds like the fit was nice and clean for others who tried it. Sharing how yours turned out could help others looking at the same setup.