Search: stake pockets tie down anchors   >  

I looked up the trailer connector wiring diagram for a 2007 Ford F-250 which should be the same as a Ford F-350 and found the 7-way trailer connector to contain the following wires: Orange = 12 Volt Power White = Ground Black/Green = Reverse Blue =…

Patrick, a green coffee pot no, unfortunately. We do have the GSI Outdoors Camping Coffee Percolator #GSI28MV which has a 6 cup capacity but is stainless steel, or, we have the GSI Outdoors Camping Coffee Percolator #37325254 which is green, but has…

Brophy hitch ball #SC23-C is made overseas. For a stainless steel option that is made in the US you would have to go to an interchangeable set, #903B. I have linked a video review of this set for you.

There is a kit that has exactly what you need with the hardware without the 7-way of the RV Upgrade Kit #ETBC7L. What you need is the Power Wire Kit for Electric Trailer Brake Controllers #BRK-ELECKIT. This has everything you are looking for, minus…

The Stake Pocket Tie-Down Anchor for Flatbed Truck or Trailer #T35Z or #T355 measure 5-1/4 inches from the bottom up to the bottom of the top plate the D-ring is on. They are 3-1/2 inches wide and 2 inches deep. They are designed to fit in 2x4 stake…

Unlike costlier brands of trailer jack the entry-level Pro Series line is not supported with the same repair/replacement parts availability as with the upper tier sister brands like Bulldog and Fulton. The few parts we have available to us are shown…

I attached a picture that details how to disassemble the Bulldog 12,000 lb jacks.

It is certainly possible for the Gen-Y Hitch Shock Absorbing 5th Wheel to Gooseneck Pin Box #GY58GR to work on your 2020 Ford F-250 Super Duty short bed, but there are likely going to be clearance issues as these are meant for long bed trucks. That…

It sounds like the left side may have a bad ground in the system or a loose ground. I would check over the complete wiring system and make sure all grounds have a good metal contact and no rust. Also check the wires to make sure the protective…

The rear stake pockets in your 2016 Chevy Silverado 1500 are shaped different than most. We carry specific anchors for them, part #P99914. Then for the standard shaped front pockets part #P99901 will match the others.

We have exactly what you need to lock the ball mount platform to the shank of your Curt Multi-Ball Adjustable Ball Mount part #D900 and to lock the shank to your hitch. What you would need is the Trailer Hitch Receiver Lock #e98881. You will need to…

Thanks for that detailed info and there is a cover that will work for you, though the 15 foot length you mentioned is the total length, including the tongue/coupler, and covers are not meant to go over that part of the trailer. I looked up your…