Does Come with Install Hardware

Question

Question:

Do you guys sell the bolt screw hardware for the t-strap?

asked by: Montrell N

0

Expert Reply:

Hey Montrell, the T-Strap Hinge part # PLR3408 does not come with install hardware. You would need to provide the hardware and pick what would work best on your trailer door based on what it's made of etc.

expert reply by: Jameson C

0

Jameson C.

12/8/2025

Hey Montrell, what did you end up using for the hardware with your T-strap hinge? Knowing what worked best for your trailer door could help others choose the right setup too.

Answer 1

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 2

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 3

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 4

Hey Jesse, cool name! That's definitely a custom project, and there isn't a single off-the-shelf kit that'll give you everything you need. For a lift-up wall that's around 10' x 6', you're looking at building the door and…

view full answer...

Answer 5

We currently offer 3 different replacement strap hinges, #2008-8, #2512, and #2212, for cargo trailers. I have included a photo showing each of these with their measurements listed. I recommend comparing these measurements to the strap hinges on your…

view full answer...

Answer 6

I would be happy to help you find the correct replacement door hinge for your 2000 Sooner Royale Horse Trailer, but I was unable to find any dimensions or information about the 03139010 hinge you mentioned. Based on the picture you provided it looks…

view full answer...

Answer 7

I recommend replacing the hinges on your 1990 Sooner SH slant trailer with the T-Strap Hinge #PLR3408-SS. These hinges are stainless steel for increased life and are stronger than the aluminum hinges you currently use. They are also have a larger…

view full answer...

Answer 8

We do carry ramp door hinges though they are not made specifically for a Snowpro trailer. The ramp door hinge #PLR1902 is steel and gets welded on; I've added a photo showing the dimensions of this hinge as well as a link to a video review for…

view full answer...

Answer 9

Hey Alison, thanks for reaching out! I looked through our whole selection of hinges but none of them match the exact design that you all already have on your Aluma trailer. What I recommend doing is using a whole different strap since you're…

view full answer...

Answer 10

Hello Bee. We do have a few 270 degree strap hinges. Take a look at the Square Corner T-Strap Hinge w/ Reverse Bracket #PLR2212-AS. This is a 12" long 270 degree aluminum hinge. This is going to be a bit longer than the hinge in your picture,…

view full answer...

Answer 11

Your fifth wheel rails with the CMI stamped on them were manufactured by Curt, and will be compatible with Curt, Draw-Tite, Husky, Reese, Valley, and other brand hitches. They fit what are called industry standard hitches. For your 2008 Ford F-350, I…

view full answer...

Does Come with Install Hardware

Product Page this Question was Asked From

Continue Researching