Replacement Strap Hinges for an Aluma Trailer with Ramp
Updated 12/15/2025 | Published 11/26/2024
Question:
HI-i have an Aluma trailer and the hinges have bound making it difficult to use. I would like to get replacement hinges. I currently cant find anything from Aluma dealers. The trailer is an enclosed one with a large fold down back door that turns into the ramp. There is also a side man door to access the front of the trailer that is located on the side. The model number is AE7125, we purchased it in 2005 or so. The VIN is XXXX I will enclose a couple of photos of the current hinges that we need to replace. The hinges on the bottom of the big door at the back are about 10 inches long and the side door hinges are about 8 inches long. Both have to go over a seal/joint. Thanks in advance.
asked by: Alison M
(click to enlarge)
(click to enlarge)
(click to enlarge)
(click to enlarge)
(click to enlarge)
Expert Reply:
Hey Alison, thanks for reaching out!
I looked through our whole selection of hinges but none of them match the exact design that you all already have on your Aluma trailer. What I recommend doing is using a whole different strap since you're struggling to find the correct design. We have the Polar Hardware Strap # PLR2212-AS which is a little longer at 12" than what you currently have, but I believe the bend in the strap will be enough to accommodate both your ramp door and your side door.
Product Page this Question was Asked From
Square Corner T-Strap Hinge w/ Reverse Bracket - 270 Degree - 12"Long - Aluminum
- Trailer Door Hinges
- Strap Hinge
- Non-Removable Pin
- Aluminum
- 12 Inch Long
- 2 Inch Wide
- Bolt-On
- Polar Hardware
more information >
Continue Researching
- Search Results: demco
- Search Results: truck bed step
- Search Results: coupler
- Search Results: buyers toolbox
- Search Results: hopkins
- Search Results: hopkins 40999
- Search Results: demco gooseneck coupler
- Shop: T-Strap Hinge for Enclosed Trailers - 8" Long - 180 Degree Rotation - Zinc Plated
- Video: What to Know About the Square Corner T-Strap Hinge w/ Reverse Bracket
- Shop: Square Corner T-Strap Hinge w/ Reverse Bracket - 270 Degree - 12"Long - Aluminum
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Way Flat Trailer Connector
- Shop: Demco A-Frame Trailer Coupler w/ Jack Hole - eZ-Latch - 2-5/16" Ball - Raw - Weld-On - 18K
- Shop: Demco A-Frame Trailer Coupler w/ Jack Hole - eZ-Latch - 2-5/16" Ball - Primed - Weld-On - 18K
- Shop: B&B Tow Plug and Safety Chain Holder - Black
- Shop: Optronics 7-Way Trailer Harness Plug Protector
- Video: Feature Review Brophy Stake Pocket Step for Flatbed Truck or Trailer
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Q&A: Recommended Flush Door Latch for Wells Cargo Trailer
- Video: Valterra Electrical Cable Hatch for RVs: The Breakdown
- Video: Review of the Ark Xtreme Off-Road Ratcheting Jack w/ 2 Wheels
- Q&A: Dimensions of Square Corner Hinge with Reverse Bracket PLR2212-SSP
- Q&A: Door Hinge for 2001 Exiss Horse Trailer
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Thumb Latch Cylinder Measurements
- Q&A: Dimensions Of The Over The Seal Strap Hinge # PLR2116-SS
- Q&A: What Hitch Weighs the Least for My 2025 Toyota RAV4 Hybrid Plug-In?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Lighting Requirements
Kate F.
12/15/2025
Hey Alison, how did the Polar Hardware strap hinge work out on your Aluma trailer doors? Knowing how the fit turned out could really help others trying to replace older Aluma hinges.