What Is The Amp Draw For The Peterson LED Clearance/Side Marker/Third Brake Light PET75PV?

Question

Question:

What is the max Amp draw for the light? I am needing to know for my light control module.

asked by: Caleb

0

Expert Reply:

Hello Caleb, thanks for reaching out. So I was not able to fine any specific info on the LED Clearance/Side Marker/Third Brake Light # PET75PV but based on the amp draw listings of similar lights it’s reasonable to assume its draw is in the same ballpark, likely between 0.1 and 0.2 amps at 12 V.

expert reply by: Jesse M

0

PET75PV
(click to enlarge)

Answer 1

Hey Lester, the Mini Clearance light part #TN68MR you referenced are only single intensity. For a similar dual intensity light you would want something like the part #PET75PV instead.

view full answer...

Answer 2

I contacted our representative at Optronics about the Mini LED Lights, part #MCL11CRKB. I have attached a side angle view of this light that our representative at Optronics sent. At this time we do not have installed pictures of the light or a video…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

What Is The Amp Draw For The Peterson LED Clearance/Side Marker/Third Brake Light PET75PV?

Product Page this Question was Asked From

Continue Researching