Will Scissor Stabilizer Jacks Fit 2021 Heartland Pioneer DS320

Question

Question:

Will these work for a 2021 Heartland Pioneer DS320?

asked by: Ashley R

0

Expert Reply:

Hey Ashley! Yes, the Scissor Stabilizer Jacks w/ Handle # TJSCHD-24-4 will work on your 2021 Heartland Pioneer DS320.

Did something happen to your original jacks?

expert reply by: Robin H

0

Scissor Stabilizer Jacks
(click to enlarge)

Robin H.

11/13/2025

Hey Ashley, how did the new scissor stabilizer jacks work out on your Heartland Pioneer? Sharing how they performed could help others looking for the same setup.

Answer 1

I can definitely see why the Command Electronics LED RV Interior Light #328-K-1051SQ9 would be a bit too bright inside your RV. While there isn't a specific dimmer switch made for this light, you should be able to purchase one from your local…

view full answer...

Answer 2

The Scissor Stabilizer Jack #TJSC-24, which also comes in a 2-pack #TJSCHD-24 and a 4-pack #TJSCHD-24-4, is a universal fit so you would need to double check our measurements to ensure they fit your travel trailer. When they are collapsed they…

view full answer...

Answer 3

Hey Edgar, I've attached a diagram below that should have all the measurements you need for the mounting brackets of the etrailer Scissor Stabilizer Jacks w/ Handle #TJSCHD-24-4. The brackets are about an 1/8" thick.

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 9

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 10

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 11

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 12

Thanks for the picture! I checked with Progressive Dynamics the replacement power converter you need for your Parallax Series 7300 Model 7345 is the Replacement Converter for Parallax/Magnetek or WFCO RV Power Centers - 45 Amp item #PD4645V.

view full answer...

Will Scissor Stabilizer Jacks Fit 2021 Heartland Pioneer DS320

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching