How Do You Mount The Jensen Pull Up Antenna?
Updated 01/07/2026 | Published 08/10/2025
Question:
What is the minimum size hole does the Jensen an110 antenna mount into? What clearance in inches is needed under the fender?
asked by: Grant B
Expert Reply:
Hey Grant,
The Jensen Pull Up Antenna, # AN110, doesn't actually mount through an exterior hole in your RV, it comes with a mounting bracket and self tapping screws that is mounted and then the antenna is hooked to. If you wanted to run the cable inside you would need to drill a 3/8" hole for the cable to run through. Otherwise the antenna uses a mounting bracket to mount.
What kind of RV/trailer are you wanting to put this on?
Dick H.
1/5/2026
Hey Nick, I have the same antenna, AN110, that I'm replacing my old one with on my pontoon. It came with no instructions. Can you send me a link with them please? I've mounted a few, and I have no idea what the keys, bracket and small screws are for. I expected to just put it in the same hole as the old one in my steering console. Appreciate the link your sending. Thanks, Dick H
Product Page this Question was Asked From
Jensen Pull Up Antenna - Top Mount
- RV Antennas
- AM/FM Antenna
- 48 Inch Cable
- Rooftop Mount
- Side Mount
- Jensen
more information >
Continue Researching
- Video: Equal-i-zer Weight Distribution EQ95-01-9450 Review
- Search Results: sway control trailer hitch ball mount
- Search Results: class iv heavy duty receiver hitch
- Search Results: trailer hitch
- Search Results: hitch mount
- Search Results: class iv trailer hitch ball mount
- Q&A: What is the Torque Spec for the Bolts that Come with 2-5/16 Inch Channel Coupler # CTA-400
- Search Results: 3024p
- Search Results: brake controller
- Shop: Brake Controller
- Shop: Replacement Spacer Rivet and Washers for Equal-i-zer Weight Distribution Head
- Shop: Replacement Spacer Washer for Equal-i-zer Weight Distribution Head
- Shop: Replacement Head Adjustment Hardware for Curt Round Bar Weight Distribution Systems
- Shop: Pro Series Weight Distribution Shank - 12" - 12,000 lbs
- Shop: Replacement Shank for Curt Adjustable Ball Mount
- Shop: Curt Adjustable Weight Distribution Shank - 8"
- Shop: Curt TriFlex NEXT Trailer Brake Controller w/ Custom Harness - 1 to 4 Axles - Proportional
- Q&A: Which Dometic SmartStart Fits Dometic Penguin II AC With Manual Controls Under Vent Assembly
- Q&A: How to Replace a Lance 6-Pin Plug w/ a Standard 7-Way Connector
- Q&A: Is There a Replacement Mounting Bracket Available For a Furrion FOD43TA-BL Monitor
- Q&A: Replacement For Lippert Slam Latch 642063 On a 2019 Grand Design Solitude 3740BH-R
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How Does an RV Water Pump Work?
- Q&A: Troubleshooting Lippert PSX2 Legs Won't Extend or Retract
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Q&A: Wiring Diagram for Advent Air Conditioner ACM135
- Article: How to Install Tire Chains
- Article: Best Bike Racks for Electric Bikes
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
Nick S.
9/2/2025
Hey Grant, did you decide to mount the Jensen antenna on your RV or trailer? I'm asking because knowing your experience could help others considering the same setup.