What Is The Power Draw Of A Reverse Lockout Solenoid
Updated 09/08/2025 | Published 06/04/2025 >
Products Featured in This Question
Question:
Do you know how many amps the reverse lockout solenoid for this does brake actuator pulls?
asked by: Ryan M
0
Expert Reply:
Hello Ryan, good question. The power draw for the reverse lockout solenoids is minimal. For example, the Titan reverse lock out solenoid part # T4748800 only draws 8 watts so it doesn't really draw much.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Dexter Zinc-Plated Brake Actuator w/ Drop, Electric Lockout - Disc - 2-5/16" Ball
- Brake Actuator
- Surge Brake Actuator
- Farm Trailer
- Boat Trailer
- Construction Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 12500 lbs GTW
- 2-5/16 Inch Ball Coupler
- 3 Inch Channel Tongue
- Disc Brakes
- Electric Lockout
- Dexter
more information >
Continue Researching
- Shop: Attwood Marine Slip-Ring Penetrating Anchor - #5 Size - Galvanized Steel
- Shop: Attwood Marine Slip-Ring Penetrating Anchor - #13 Size - Galvanized Steel
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Replacement Titan Surge Brake Actuator for Model 10 Part 3241639
- Q&A: Replacement Surge Brake Actuator To Replace Tie Down Model 125 12,500LB Drop Actuator
- Q&A: Replacing Master Cylinder in Titan Model 10 Actuator on Boat Trailer
- Q&A: How To Measure For Replacement Overhead Springs On A Trailer Door
- Q&A: Will DeeMaxx 10" Disc Brakes Fit with 14" Americana Wheels?
- Q&A: Replacement Master Cylinder for a Titan Model 20 Actuator w/ Drum Brakes
- Q&A: Looking For A Demco DA86 Actuator For Drum Brakes Specifically
- Article: Boat Trailer Guides: Which are the Best?
- Article: Trailer Wiring Diagrams
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Tell the Weight Rating of a Trailer Axle



Jesse M.
9/8/2025
Hey Ryan, did the information about the power draw help you with your brake actuator setup? I'm asking because knowing how it worked out for you could assist others with similar questions.