Will Mercedes-Benz Sprinter Van Adapter TH308073 Work With Standard And High Roof Models?

Question

Question:

I have a 2010 Sprinter 2500 standard roof with no factory roof rails. Not clear if the brackets fit both standard and high roof models.

asked by: Russ

0

Expert Reply:

Hello Russ, thanks for reaching out. According to Thule, the Mercedes-Benz Sprinter Van Adapter for Thule HideAway Awnings # TH308073 will work with both standard and high roof models.

expert reply by: Jesse M

0

Mercedes-Benz Sprinter Van Adapter for Thule HideAway Awnings TH620001 and TH620002
(click to enlarge)

Jesse M.

9/29/2025

Hey Russ, did the Thule adapter work out for your Sprinter's roof? I'm curious to know because it could help others with similar setups.

Answer 1

We have a really nice option for an awning that will work with your high-top Ram ProMaster 2500 van, with the best one being from Thule. What you will need are the awning, as well as the adapter you mentioned, with the correct parts being the…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 9

Hello Todd, great question. The Yakima EXO Swing Away and Gear Locker #Y62VR is going to allow you to open the rear doors on your 2025 Sprinter 3500XD RV at around 90 degrees. Then with the box removed you may face a clearance issue with your…

view full answer...

Will Mercedes-Benz Sprinter Van Adapter TH308073 Work With Standard And High Roof Models?

Product Page this Question was Asked From

Continue Researching