2003 Subaru Forester Parts to Fit Thule Square Bar to Flush Mount Rails

Question

Question:

2003 Subaru forester flush oem railing. I own Thule square bars and asking what correct Thule foot mounts that works with oem flush roof railings. Please include foot and lock product numbers. Thank you

asked by: Jose M

0

Expert Reply:

Hey Jose, thanks for reaching out!

If you have the new style Thule square bars with the slots on the undersides, like the part # TH712200, then you'll need these Thule parts:

- Evo Flush Rail Feet # TH710601
- Fit Kit # TH75JE
- Lock Kit # TH450400

For the older style of Thule square bars that don't have the slots on the undersides, we'll need to get you setup with some parts from Inno, as Thule doesn't make parts that fit with that crossbar anymore. Here are the Inno parts you need:

- Inno Feet # INTR (comes with locks)
- Fit Kit # INTR104

Either way, make sure your Thule crossbar is the 47" length so it will properly fit. What do you plan on using the roof rack for?

expert reply by: Jon G

0

Jose M.

5/9/2025

Thank you!!!

Jon G.

5/9/2025

@JoseM Happy to help out!

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 5

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 6

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 7

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 8

Hello John, thanks for reaching out. Yes, we do have a Thule roof rack that will allow you to install the Hullavator #TH898 on your 2015 Subaru Forester. For that I recommend the following: - Thule WingBar Evo Roof Rack for Raised Rails - Aluminum -…

view full answer...

Answer 9

Hey Roy, congrats on the new SUV! Listed below are the parts you'll need to add a roof rack to your 2026 BMW X3 that will allow you to have enough clearance for a lift assist kayak carrier or two. This setup is designed for the 2026 X3's with…

view full answer...

2003 Subaru Forester Parts to Fit Thule Square Bar to Flush Mount Rails

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching