Lippert Smart Trailer Jack Just Clicking When Pressing Buttons
Updated 09/26/2025 | Published 04/24/2025
Question:
Jack is clicking when I press buttons. Jack has power but in not working
asked by: Stephen T
Expert Reply:
Hey Stephen,
The first thing I think of when I hear that clicking symptom is that the trailer jack just isn't getting enough power to fully operate. Check to make sure your ground connections are securely attached and then test the battery itself that you're pulling power from. You need to make sure you're getting 12+ volts at the terminal. If you aren't, then you'll need to charge it up before hooking up the jack again.
Are you able to manually operate the jack okay?
Product Page this Question was Asked From
Lippert Smart Jack Electric Trailer Jack w/ Footplate - A-Frame - 22-1/2" Lift - 3.5K - Black
- Camper Jacks
- Pop Up Camper
- Teardrop Camper
- Travel Trailer
- A-Frame Jacks
- Steel
- 3001 - 4000 lbs
- Electric Jack
- 22-1/2 Inch Lift
- Bolt-On
- 1 Jack
- Lippert
more information >
Continue Researching
- Q&A: Replacement For Lippert Power Tongue jack On A Jayco Jay Flight 32BHDS
- Article: The Best Electric Trailer Jacks of 2025
- Q&A: Can I Upgrade a WF-8955PEC-GE Converter for LiFePO4 Batteries with the WF76FR?
- Q&A: Will e74GV work on a 2015 Ford F-250
- Q&A: Testing a Vehicle Side 7-Way Trailer Connector for Proper Function
- Q&A: Can PowerMax Wireless 50A RV Power Center and Distribution Panel be Used in Cargo Trailer
- Q&A: Recommended 15k Furrion Chill Low-Profile AC w/ Heat Pump for a Ducted Setup
- Q&A: Replacement Roll Bar for 72" Slide-Topper Awning
- Article: Trailer Wiring Diagrams
- Article: RV Converter vs Inverter Explained
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Measure for Motorhome Steps
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: Is It Illegal to Leave My Hitch on My Truck?
Chris R.
9/26/2025
Hey Stephen, did you have a chance to check the ground connections and test the battery voltage for your trailer jack? I'm asking because your experience could really help others facing similar issues.