Replacement Tarp for a 2016 Ford F-350 8' Bed Extang Trifecta Tonneau Cover

Question

Question:

I have a Trifecta truck bed cover tri-fold and need to replace the tarp. Its a 8ft bed on a f350. Do you carry the replacement tarp? Thanks!

asked by: Matt L

0

Expert Reply:

Hey Matt, thanks for reaching out!

I'm guessing your Ford F-350 is a 2016 model since that's what you have in our fitguide.

For replacement Trifecta tarps we have the part # EX94725-20 for the Signature 2.0 and the part # EX92725-20 for the standard 2.0.

Did your old tarp just wear out over time?

expert reply by: Jon G

0

Matt

4/21/2025

The existing tarp has several holes in it... I just bought the truck What's the difference between the Signature and the Standard?

Jon G.

4/21/2025

@Matt They just go to specific tonneau covers. I added both since you hadn't called out something specific. If you let me know what model you have (it should be on a label on the tarp) that will let you know which replacement tarp is the correct one.

Matt

4/22/2025

@JonG I'm not seeing a label that gives a model number. Yes I have a 2016 f350 SRW with 8ft bed.

Jon G.

4/22/2025

@Matt Great. What's the model number?

See All (7) Replies to Matt ∨

Answer 1

Great question, Brady! The jounce bumper inside the Air Lift LoadLifter 5000 Ultimate Air Helper Springs #AL88289 is basically there so that in the unlikely event that the air bags give out, your truck still has the jounce bumper to fall back on. So…

view full answer...

Answer 2

Hey Noah, for your 1999 Ford F-250 long bed the correct replacement Extang Trifecta 2.0 tarp would be the part #EX92725-20,

view full answer...

Answer 3

The correct replacement tarp for your Extang Trifecta on your 1998 Ford F-150 6-1/2' bed is the Replacement Tarp for Extang Trifecta Soft Tonneau Cover #EX43710A.

view full answer...

Answer 4

For the Extang Trifecta 2.0 part #EX92415 that fits your 2011 Ford F-150 long bed the correct replacement tarp is the part number #EX43415B.

view full answer...

Answer 5

I am happy to determine the replacement cover for you but I would need the serial number off of your older Extang cover. The easiest way is to locate the serial number. Most of the time the serial number can be found on the driver's side front…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 12

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Replacement Tarp for a 2016 Ford F-350 8' Bed Extang Trifecta Tonneau Cover

Continue Researching