What Size Fitting would Be Needed to Add Tee Fitting to Valterra HydroFlush

Question

Question:

I recently purchased the black tank flush kit VAL42RB. I installed it and am very pleased with it. I plan to add a second nozzle using a tee fitting on the clear hose. Can you tell me what size barbed tee I need? Thanks!

asked by: Jacob S

0

Expert Reply:

Hey Jacob, the Valterra HydroFlush RV Black Tank Flush System # VAL42RB has 3/4 inch diameter hose so that would be the size fittings to use to add a tee.

expert reply by: Jameson C

0

Jacob S.

4/15/2025

Thanks for the quick reply! I don’t see any 3/4 in the RV fresh water fittings category. Do you have a part number I can order with?

Jameson C.

4/15/2025

@JacobS Its not a standard RV water fitting so that's why you probably didn't see anything for it on our site or on similar sites. Basically it's the same size as garden hoses and garden hoses use 3/4 inch hose so that would be correct size to use. Keep in mind the hose you have would stretch a bit and if you use a band clamp to secure it you wouldn't have to be super exact.

Answer 1

The Connector Kit, part #DZ97960 is designed to work with an auxiliary tank like part #DZ91752X. This system has a gravity feed to transfer diesel fuel from your auxiliary tank to your OEM tank but there is no automatic shutoff. I called my contact…

view full answer...

Answer 2

The Connector Kit for DeeZee Truck Bed Auxiliary Tank - Later Model Chevy/GMC, Dodge, and Ford #DZ97960 has a flow rate that is very slow. A customer stated that with the kit alone it takes about 10 minutes to transfer 1 gallon of diesel fuel due to…

view full answer...

Answer 3

Hey Keven, thanks for reaching out! The UWS Matte Black 75-Gallon Steel-Aluminum Combo Transfer Tank #UWS39XR measures 48-1/2" long x 26-3/4" tall x 27" wide which, according to my research, should fit just fine in the bed of your 2019…

view full answer...

Answer 4

Hey Jacob, the drain plug of the UWS Matte Black 75-Gallon Steel-Aluminum Combo Transfer Tank #UWS39XR that you referenced is a 3/8 inch diameter bolt.

view full answer...

Answer 5

The fuel line that comes with the Connector Kit #DZ97960 that you referenced is 5/16 inch and the fitting that you referenced that threads into a fuel tank like the part #DZ91752X is 5/8 of an inch. I confirmed this with my contact at DeeZee.

view full answer...

Answer 6

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 7

Hey Tod, the two UWS boxes have different shapes and capacities. If you check out the attached pictures you can see the differences between the part #UWS08298 and #UWS01044 to get a better idea. The #UWS01044 has a slightly smaller capacity at 8.2…

view full answer...

Answer 8

The towing capacity of the 2003 Chevrolet Avalanche 1500 with 5.3L V8 and 4.10 rear axle is 8100-lbs. For a 7600-lb GVWR travel trailer the resulting 500-lb safety margin is adequate/low-ish. With a trailer that weighs substantially more than the tow…

view full answer...

Answer 9

The back portion of the UWS Secure Lock Truck Bed Chest #UWS08298 is 12-1/2" tall and the canister for the RetraxPRO MX Hard Tonneau Cover #RT80384 is going to sit 11-5/8" down from the top of the bedrails. From what I can find online a…

view full answer...

Answer 10

Hey Mark, the only real downside to an offset ball like the Gen-Y part #GY43XR is going to be that it costs more typically and it would take up more room when stored compared to a non-offset ball like the #C38CR. The handling and weight carrying…

view full answer...

Answer 11

Thanks for all the details Mike, that helped a lot. For what you’re wanting to do, I’d recommend the Furrion Chill Cube 18,000 BTU ductless setup, #FR59TD in white or #FR27TD in black. Since you’re adding a separate rear bedroom AC and won’t need the…

view full answer...

Answer 12

Hello Kevin, Thanks for writing in. The main difference between the Power Watchdog Surge Protectors #HU67FR and #HU42VR comes down to the monitoring capability, housing design, and surge protection rating. The #HU67FR is the newer Generation 2 model.…

view full answer...

What Size Fitting would Be Needed to Add Tee Fitting to Valterra HydroFlush

Product Page this Question was Asked From

Continue Researching