Chrome Trim LED Clearance Light for a Trailer Towed by a Motorcycle
Updated 06/16/2014 | Published 06/14/2014
Question:
Is there a LED replacement for the Peterson Red Flush Mount Clearance Light with Chrome Plating, 126R . I am wanting to lower my amp draw on my motorcycle when pulling the trailer. Thanks.
asked by: John
0
Expert Reply:
Take a look at Optronics light # MCL71RB. This is an LED clearance light with chrome trim. It measures 3-3/4 inches by 2-1/4 inches by 1/2 inch. It only draws 0.054 amps at 12.8 volts so that will help with reducing the power draw. I have linked a video review of this light for you.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Peterson Clearance or Side Marker Trailer Light - Incandescent - Chrome Plated - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Rectangle
- Recessed Mount
- Non-Submersible Lights
- Incandescent Light
- 3-3/4L x 2-1/4W Inch
- Red
- Peterson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Electric Trailer Jack Powered By The Towing Vehicle's 7-Way
- Q&A: Recommended Replacement Side Marker Light for Exiss Horse Trailer
- Q&A: Replacement Trailer Clearance LED Lights with 2 3/4 Mounting Hole Spacing
- Q&A: Replacement Slam Latch for a LCI Latch
- Q&A: Replacement Lens for Trailer Taillight SAE AP2 99 DOT
- Q&A: Replacement For Slide-Out Motor 130-1146
- Q&A: Replacement for P10490 Grease Seal
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Curt Echo Full Review
- Article: Best Landing Gear
- Article: Trailer Jacks
- Article: Ram Trailer Tow Prep Package
- Article: Trailer Wiring Diagrams
- Article: Trailer Lighting Requirements