What is Length of Spring Bars that Come with Curt Weight Distribution System C69JR.

Question

Question:

How long are the soring bars on the c69jr Curt hitch

asked by: Ray B

0

Expert Reply:

Hey Ray, the length of the spring bars of the Curt TruTrack kit part # C69JR that you referenced is right at 31 inches which happens to be basically the standard length. Would that dimension work for you or do you have a clearance issue with your trailer frame?

expert reply by: Jameson C

0

Jameson C.

10/30/2025

Hey Ray, did the 31-inch spring bars on the Curt TruTrack hitch give you the clearance you needed with your trailer frame? Your update could make it easier for the next person checking fit on a similar setup.

Answer 1

The button on the top right of your Tekonsha Prodigy P2 #90885 is called the "Boost Button". This basically just determines how aggressive the brakes on your trailer will act. The "b" setting is normal and the you have b.1, b.2,…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 5

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 6

-Hey Tom, Equal-i-zer makes frame brackets for 8 inch trailer frames. For that you would need the part #EQ90-02-5378 for outer link and then for an inner link part #EQ90-02-5208. You'd need two of these with the system you order since the…

view full answer...

Answer 7

We currently have 3 different trailer jack support plates. I have included other dimensions in the included photos except for #BDSPB50 which was not available. #DL22763 is 1/8 inch thick. #BD003135 is 1/8 inch thick. #BDSPB50 is 1/8 inch thick. The…

view full answer...

Answer 8

Hey Mike! The Soft Start Kit for Coleman-Mach RV Air Conditioners #CM56RR is designed to work with 45000, 47000, and 48000 air conditioners. Based on those numbers I'm assuming you those are 38000 series, but the model number doesn't always…

view full answer...

Answer 9

Welcome back Don! The Equal-i-zer Weight Distribution System w/ 4-Point Sway Control item #EQ37120ET is exactly what I would recommend using. This is a solid reliable system and the built in sway control will make a noticeable improvement in ride…

view full answer...

Answer 10

Hi Garrett! We do have options for your 2015 Kenworth T270, but there are not going to be any custom fit hitches available. If I were doing this, I would go with the Curt Class 5 Universal Weld-on Hitch w/ Brackets - 2-1/2" Receiver - 44"…

view full answer...

Answer 11

Hey Frank. I can give you the dimensions of the shank on the B&W Continuum item #BW28FR but you're going to need to take the measurements on your Silverado 3500 to confirm the tailgate will open. From the hitch pin hole to the center of the…

view full answer...

What is Length of Spring Bars that Come with Curt Weight Distribution System C69JR.

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching