Why Do Longer Rods than 8 Feet Need to be Broke Down with Malone Striper-4 Fishing Rod Carrier

Question

Question:

Why do you have to break down rods over 8 feet on a truck rack real truck elevate rack on Toyota tundra

asked by: George T

0

Expert Reply:

Hey George, this is a great question but if you consider how long the typical vehicle roof is and where the rear crossbar is located that if you put 8 foot rods at that point it would hang really far forward and would potentially cause issues and could hit windshield etc.

expert reply by: Jameson C

0

Jameson C.

10/30/2025

Hey George, did the explanation about rod length and rack placement help make sense of why longer rods need to be broken down on your Tundra? Knowing how it worked out with your Striper-4 carrier could help others hauling longer rods too.

Answer 1

The Malone AirFlow2 Roof Rack #MAL84AR you were looking at will fit your 2024 Subaru Forester Wilderness edition. Our fit guide can be a little confusing since these particular crossbars say it fits all models, excluding Wilderness and Wilderness…

view full answer...

Answer 2

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

The Demco Hydraulic Trailer Brake Actuator part #DM72VR should be a direct replacement for the Atwood 61101 Brake Actuator that you have now. This newest updated it rated at 7K instead of 6K. This is a bolt on option that mounts on 3" centers.…

view full answer...

Why Do Longer Rods than 8 Feet Need to be Broke Down with Malone Striper-4 Fishing Rod Carrier

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching