Can Air Gauge On Air Lift Air Shock Controller Be Replaced With 100 PSI Gauge
Updated 11/03/2025 | Published 01/06/2025
Question:
I see this kit comes with a 200 gauge. Its there any way to just get a 100 gauge instead to monitor? Really hard to hit the minimum required 5lbs of air for the air bags with the high psi gauge. I dont really want to purchase the other kit with the correct gauge, it costs more.
asked by: Jeff
Expert Reply:
Hi Jeff; any gauge with a 100 psi max from Air Lift doesn't match this style to replace the one that comes with the # AL25804. The reason the gauge goes up to 200 psi is because this is a 160 psi compressor and it needs to be able to show the higher pressure. What I would do is run it up to the first red mark which is 10 psi, then carefully release air until it barely touches the stopping point which will be 5 psi. The lowest point of the needle sits at 5 so as soon as it touches you're set.
(click to enlarge)
Product Page this Question was Asked From
Air Lift Air Shock Controller Compressor System for Air Shock Absorbers - 100 psi
- Air Bag Compressor Kit
- In-Cab Gauge
- Single Path
- Analog Display
- No Tank
- Light Duty
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Suspension Enhancement
- Search Results: air lift air bag compressor kit
- Shop: Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle
- Search Results: air lift gauge
- Shop: Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle
- Shop: Air Lift Load Controller II Compressor System for Air Helper Springs - Single Path
- Video: Choosing the Right Vehicle Suspension Upgrades
- Video: Air Lift LoadLifter 5000 Rear Axle Air Helper Springs Review
- Shop: Air Lift Union Tee for 1/4" Air Lines
- Search Results: air bag compressor kit
- Shop: MB Sturgis Propane Pigtail w/ Back Check - RV Type 1 x 1/4" Male NPT - 1'
- Shop: Air Lift LoadLifter 5000 Ultimate Air Helper Springs with Internal Jounce Bumpers - Rear Axle
- Shop: RoadActive Suspension Custom Leaf Spring Enhancement Kit - Heavy Duty
- Q&A: Will the Air Lift LoadLifter 5000 Fit with a B&W Gooseneck Hitch on a 2012 F250 SB CC?
- Q&A: Difference Between The Less Expensive AND More Expensive Air Lift Compressor Kits
- Q&A: Correct Air Lift LoadLifter 5000 Air Helper Springs for a 2014 Ford F-250
- Q&A: Which are Better for a 2011 Ford F-250, Timbrens or AirLift Airbags?
- Q&A: Will Air Lift Suspension Enhancement System Work On 2011 Ford F-250 With B & W Gooseneck
- Q&A: What Air Bags Work with the B&W Turnoverball Part # BWGNRK1116 on a 2018 Ford F-250
- Q&A: Can Air Bags be Installed on a 2011 Ford F-250 with B&W Gooseneck Hitch Installed
Robin H.
11/3/2025
Hey Jeff, how did it go using the 200 psi gauge on your Air Lift compressor to find that 5 psi mark? Were you able to get the pressure dialed in the way you wanted? Your update could make it easier for others working with the same setup.