How Many Sensors Can A SeeLevel Tank Monitoring System Connect To
Updated 12/15/2025 | Published 11/22/2024
Question:
How many tank sensor will one monitor panel read?
asked by: Tracy
Expert Reply:
Hey Tracy,
The amount of sensors a SeeLevel monitor can connect to depends on the model of the monitor. Each one is set to handle a certain amount of tanks and you can also stack a second sensor on each tank for increased height/monitoring on taller tanks. I've attached a chart below that shows each monitor and what functions they offer so that you can pick the right fit for your setup. From there you'd want to go take a look at your tanks and start figuring out where the sensors could be attached and measure the height of the tanks so that we can figure out which sensor size would be best.
(click to enlarge)
Product Page this Question was Asked From
SeeLeveL RV Holding Tank Monitoring System - Fresh, Gray, Black, Propane
- Smart RV
- Monitoring System
- Propane Tanks
- Water Tanks
- Digital Display
- Monitors Only
- SeeLeveL
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Search Results: rhino rv sewer adapter pro
- Search Results: tank sensors
- Search Results: camco rhino rv sewer adapter pro ~ clear sewer hose elbow with drain l
- Search Results: watchdog 30 amp
- Search Results: mopeka
- Search Results: se67vr
- Search Results: gauges and sensors propane accessories
- Shop: Floor Mats
- Shop: Van Cargo Mat
- Shop: Replacement Surge Module for Power Watchdog Surge Protector with Emergency Shut Down - 30 Amp
- Shop: Power Watchdog Surge Protector with Bluetooth - Portable - 30 Amp
- Shop: SeeLeveL RV Holding Tank Monitoring System - Fresh, Gray, Black, Propane
- Shop: Portable Power Watchdog Surge Protector with Bluetooth and Emergency Shut Down - 30 Amp
- Shop: EZ Coupler 4-in-1 Threaded RV Sewer Adapter with 90-Degree Elbow Fitting - Clear
- Shop: Portable Power Watchdog Surge Protector with Bluetooth, WiFi, and Emergency Shut Down - 30 Amp
- Shop: Replacement Check Valve/Vacuum Breaker for Factory RV Tank Flushing Systems - 1/2" MPT
- Q&A: Recommended Torflex Lift Kit For Tandem 2,900lb Dexter Torflex Axles
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Measure for Trailer Hitch Drop
- Shop: Suspension Enhancement
- Video: How to Choose a Trailer Brake Controller
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Shop: Brake Controller
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Video: A Look at the Power Mountain Tallboy 6 Ton Off-Road Bottle Jack with a Military Cargo Trailer
on Propane Accessories
Lazer S.
12/15/2025
Hey Tracy, how did things go once you checked your tanks and measured their height for the SeeLevel monitor setup? Knowing which sensor size ended up fitting best could help others planning a similar system. Your update could make it easier for the next person with the same question.