Parts Needed To Install Curt Spectrum Trailer Brake Controller On 2016 Ford F-150 With Factory Tow

Question

Question:

will the c58yv fit my 2016 f150, It came with the to package and has the 7 way plug and the 4 way on my bumper, I like the dial part for this application, does it come with everything I need to install or must i also get a special harness?

asked by: Sonny W

0

Expert Reply:

Yes, Sonny. The Curt Spectrum Brake Controller # C58YV you found will plug and play into your 2016 Ford F-150. This controller comes with the correct harness to plug into your factory brake controller plug in. Then you will be able to mount the main box under you dash and stick the control knob where it is most convenient for you to reach on the dash.

expert reply by: Bud M

0

Sonny W.

11/7/2024

Thank you Bud, I had purchased the factory Ford controller and can install it myself but, then I'm supposed to take it to the dealer and pay like 2500 dollars for them to set up the computer, my understanding is with your setup this step is unnecessary?

Bud M.

11/8/2024

@SonnyW That is correct. The Curt controller does not require any dealer programming.

Answer 1

On your Ford 2010 F-150, the harness location should be located under the dash, above the brake pedal and taped to another harness. I have attached a photo that shows the typical location for the harness location on your truck. If you have the…

view full answer...

Answer 2

For your 2016 Ford F-150 the brake controller I recommend is the Prodigy P3 part #90195 which is the most advanced and easiest to use brake controller on the market that senses how hard you are applying the truck brakes and applies the same intensity…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

To install a Redarc Tow Pro Liberty in your 2023 Toyota Tacoma Sport you will need the following parts: Redarc Tow-Pro Liberty Brake Controller item #RED24FR Plug-and-Play Wiring Harness for Redarc Tow-Pro Trailer Brake Controllers item #RED99FR…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 9

Hey Bob. There's two possible locations for the brake controller port on your 2026 Ford F-150. The most likely one is on your dash behind the coin holder above the 4WD knob. It'll be connected to the back of the coin tray which is only…

view full answer...

Answer 10

You're right, the mounting bracket is unique (in a good way) for the Curt TriFlex NEXT Trailer Brake Controller #C24VV. The bracket is smaller and all you do is put the included adhesive tape on the bracket and stick it wherever you like under…

view full answer...

Answer 11

Hi Richard! The best brake controllers on the market for your 2023 Ford Explorer XLT are going to be from Redarc. They're super easy to use and set up, and they are very reliable. They are the ones to get. Since you said you will be towing a…

view full answer...

Answer 12

Hey Phil, If you're looking for the factory wire harness for a plug and play connection you'll find a connector that's gray with a red/orange center like the plug on the Curt Custom Wiring Adapter for Trailer Brake Controllers #C51436.…

view full answer...

Parts Needed To Install Curt Spectrum Trailer Brake Controller On 2016 Ford F-150 With Factory Tow

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching