Location For Brake Controller Adapter # C51436 To Plug Into On 2010 Ford F-150

Question

Question:

The C51436 adaptor does not fit into my Ford F150 plug under the dash. What adaptor do I need to make this work?

asked by: Gary L

0

Expert Reply:

On your Ford 2010 F-150, the harness location should be located under the dash, above the brake pedal and taped to another harness. I have attached a photo that shows the typical location for the harness location on your truck. If you have the shifter in the center console of your F-150 it will be located under the center console. I have attached the installation instructions for the Curt Custom Wiring Adapter, part # C51436. The instructions show the typical installation locations for the adapter.

expert reply by: Jeffrey L

0

click to enlarge

Answer 1

There are a few differences between the two controllers. The Voyager has been around for a looooooooong time. It uses an internal pendulum to determine how quickly the tow vehicle is braking. In order to operate correctly, this level of the pendulum…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 5

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 9

Hey Keith, I don't have that exact number but if you check out the picture I attached you can see that the hitch opening is flush with the tow hooks.

view full answer...

Answer 10

Hey Dan, thanks for getting in touch. And good questions. For starters, there is no way to actually increase the vertical load rating of the Curt #C31083 front hitch. 500 lbs is the limit, and I cannot recommend using that to move a 750 lb tongue…

view full answer...

Answer 11

The Draw-Tite Front Mount Trailer Hitch Receiver #65067 and the Curt Front Mount Trailer Hitch Receiver #C31083 are both confirmed to fit your 2020 Ford F-150. They are very similar in design and mount to the same locations on the frame, however the…

view full answer...

Answer 12

Hey Eric, we have the Hellwig rear sway bar part #HE77FR that is a fit for your 2019 Ford F-150 and would do a great job tightening up the handling of your truck once the camper is on. You can also fine tune how stiff you want the bar to feel as…

view full answer...

Location For Brake Controller Adapter # C51436 To Plug Into On 2010 Ford F-150

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching