Do The Air Lift 1000 Heavy Duty Air Helper Springs Come With Schrader Valves?
Updated 12/22/2025 | Published 10/06/2024
Question:
My air bags came with schrader valves. I saw in the video the air bag before installing didnt have one. Do they get removed permanently before installing the air stem? Thanks
asked by: Joe
0
Expert Reply:
Hello Joe, thanks for reaching out. The Air Lift 1000 Heavy Duty Air Helper Springs for Coil Springs # AL60828HD also have schrader valves, but they are not connected to the air bags themselves. There is an air line that attaches to the bag and allows the schrader valves to be attached near the bumper for easier access.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Air Lift 1000 Heavy Duty Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Towing/Load Leveling
- Air Springs
- Suspension Only
- Light Duty
- Rear Axle Suspension Enhancement
- Air Lift
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Parts to Improve Ride Quality on 2025 Jayco Greyhawk 27U
- Q&A: What Air Lift Air Bags and Wireless Air Compressor do I Need for my 2021 Dodge Ram 1500?
- Q&A: Which TorkLift TIe-Downs For 2021 Ram 1500 With 5-1/2' Bed, Factory Hitch & no Boards Under Bed
- Q&A: Best Replacement Bump Stop for a Sagging Rear End on a 2019 Ram 1500
- Q&A: Do I Have to Remove the Bump Stops to Install the Pacbrake Alpha HD Air Bags on a 2022 Ram 1500?
- Q&A: Recommended Gooseneck Hitch for a 2025 Ram 2500
- Q&A: Can Round Bars of Fastway e2 be Upgraded from 800 to 1,000 lb
- Article: Stability Control for Heavy Duty Vehicles
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Performance Chips and Modules
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Determining Trailer Tongue Weight
- Article: How to Measure for Trailer Hitch Drop
- Article: The Best Towing Mirrors
Jesse M.
12/22/2025
Hey Joe, how did things go with the Air Lift 1000 air helper springs once you connected the air lines and mounted the schrader valves near the bumper? Knowing how the setup worked could help others with the same question.