Can Fan Be Replaced on Magnetek Power Converter 6300a/6332
Updated 01/05/2026 | Published 09/20/2024
Question:
Is it possible to replace the small cooling fan in the 6300a model 6332 converter
asked by: Chris
0
Expert Reply:
Hello Chris; looking at their old manual the fan can be replaced but you will need to find a 110V AC fan not a 12V DC fan. The fan only runs when hooked up to shore power. I'm guessing this is pretty old so you may want to consider completely replacing it with # PD4135K rather than spend the money on parts as they begin to fail.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Replacement Section for AC/DC Power Distribution Panel - 35 Amp
- Accessories and Parts
- RV Power Converter
- Converter Section
- 35 Amp
- Progressive Dynamics
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Magnetek Series 6300A Model 6332 Replacement Converter
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Replacement Converter for your Magnetek Converter Series 6300 Model 6332
- Q&A: Series 6300A Model 6332 Magnetek Replacement Converter
- Q&A: What is the Correct Replacement Converter for Parrallax 7300 Model 7355 Converter
- Q&A: Replacement Lower Unit for Magnetek 6332 Series 6300
- Q&A: Magnetek 6336 Replacement Converter
- Article: Spring Towing Readiness Checklist
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: How to Install Tire Chains
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
Robin H.
1/5/2026
Hey Chris, how did things go with replacing the fan in your 6332 converter? Did you end up finding a 110V AC fan or decide to go with the PD4135K instead? Your update could make it easier for the next person with the same issue.