Could Ark Ezi Guides part # AR64FR Install with Boat on Trailer

Question

Question:

Can I install without taking the boat off? 14 ft alumacraft

asked by: Richard S

0

Expert Reply:

Hey Richard, I wouldn't say it's impossible to install the Ark Ezi Guides part # AR64FR with your boat on the trailer but it's going to make it more challenging. At worst you could mount them and then if needed adjust them higher with the boat off the trailer.

expert reply by: Jameson C

0

Jameson C.

1/12/2026

Hey Richard, how did it go mounting the Ark Ezi Guides with your boat still on the trailer? It’d be great to hear if you were able to get them adjusted where you wanted. Your update could make it easier for others working on a similar setup.

Answer 1

The installation process of the Ark Ezi-Guides Self-Aligning Boat Trailer Loading System -part #AR84FR is very easy and can be done by you easily. It will use u bolts to wrap around the trailer frame and you will then tighten them down with either a…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 4

I don't have a video I can share with you, so the attached photos are the best I can do to hopefully give you an better idea of how the Ark Ezi-Guides Self-Aligning Boat Trailer Loading System - 20' to 28' Long Power Boat #AR84FR work.…

view full answer...

Answer 5

Hello Craig. The Ark Ezi-Guides Self-Aligning Boat Trailer Loading System #AR84FR can absolutely be used on a bunk trailer. As long as you have the 1.96" to 2.57" cross beam to mount the U-bolts you can install these basically wherever you…

view full answer...

Answer 6

Hey Steve! What kind of boat do you have? The untreated southern yellow pine used in CE Smith bunk boards is one of the best possible options and what I recommend. This is highly resistant to decay and bugs. It also has a high resin content which…

view full answer...

Answer 7

The Superwinch gets wired to an ignition switch, so it isn't something that is meant for a boat trailer. The fastest 12 volt electric winch that can be powered with a 12 volt battery with a boat trailer is the Dutton-Lainson StrongArm 12-Volt DC…

view full answer...

Answer 8

Though we do not have an option that would have a perfect 90 degree angle, I may still have something that would work. The CE Smith #CE27610 is a little smaller and typically installed on the outside of a trailer frame, but can be used however…

view full answer...

Answer 9

You sure can Mark! I attached pictures below of both the Air Lift LoadLifter 7500 XL item #AL57531 and the Hellwig Big Wig Rear Anti-Sway Bar item #HE24MR installed. You'll see that the sway bar mounting locations are in different spots than the…

view full answer...

Answer 10

The CE Smith Roller-Style Guide-Ons for Boat Trailers #CE27610 measure 17-1/2 inches horizontally. It mounts on 3 inch frames and roughly 3 inches of it is a portion which cannot be adjusted to so you will have approximately 11-1/2 inches that you…

view full answer...

Could Ark Ezi Guides part # AR64FR Install with Boat on Trailer

Product Page this Question was Asked From

Continue Researching