How to Determine if a Gooseneck Trailer and Truck will have Clearance to Make 90 Degree Turns
Published 05/21/2014
Question:
i have a 1999 dodge 2500 shortbed club cab and was wandering how much turning clearance i will have with a 7 foot square nose on the trailer
asked by: Brandon
Expert Reply:
In order to determine if you would have enough clearance to make a 90 degree turn with your 1999 Dodge Ram 2500 you will need to take a few measurements and plug them into this formula.
(A + B) - C = Clearance
A = Distance from the gooseneck ball to the truck cab
B = Offset used, like if you used a Offset Extension Ball # 19308
C = Width of the nose of the trailer divided by 2.
To determine A you will need to measure 41-5/8 inches from the rear of the truck bed, and then measure from that point to the truck bed as that is where the center of the gooseneck ball will be.
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: rv air conditioners
- Search Results: roof membrane rv roof repair
- Search Results: grey tank valve
- Search Results: onan
- Search Results: 9 inch jack foot
- Search Results: trailer jack
- Search Results: wheel liner
- Q&A: Recommended Replacement Brakes for Axletek 12" Electric Brakes
- Q&A: Replacement Brake Assembly for Axletek 44-GG
- Q&A: Replacement Hub/Drum Brake Assemblies for B44EA-22 BD3-6553S
- Shop: Dexter Trailer Hub and Drum Assembly for 3,500-lb Axles - 10" Diameter - 6 on 5-1/2
- Shop: MORryde RV Slide Out Fridge Tray - 22" x 37-1/2" - 200 Percent Extension - 225 lbs
- Shop: Westlake ST235/85R16 Radial Trailer Tire - Load Range G
- Shop: MORryde RV Slide Out Fridge Tray - 26-1/2" x 17-1/2" - 200 Percent Extension - 225 lbs
- Shop: Gooseneck Hitch
- Shop: GE Appliances Installation Bolts for RV ACs - Qty 4
- Shop: Valterra Waste Valve for RV Gray Water Tank - 1-1/2" Diameter - Hub to Hub
- Shop: LaSalle Bristol Long Sweep Elbow Fitting for RV Sewer System - ABS Plastic - 90 Degree - 1-1/2"
- Shop: Trailer Wiring
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Shop: Trailer Hitch
- Article: Trailer Wiring Diagrams
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Curt T-Connector Vehicle Wiring Harness Review C56040
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Shop: Suspension Enhancement
- Shop: Brake Controller
on Gooseneck Hitch
