How do Lippert Ground Control 3.0 Leveling System Landing Gear Jacks Mount to Trailer
Updated 01/19/2026 | Published 08/12/2024
Products Featured in This Question
Question:
Is there brackets for the tall jacks, I dont see them in any pictures.
asked by: Vince
Expert Reply:
Hey Vince, thanks for reaching out!
The front jacks (landing gear) that come with the Lippert Ground Control 3.0 Leveling System # LC358590 will mount using the weld stops on the landing gear and the existing brackets on your rig. The bracket will look like part # LC113511 and will already be welded to your trailer frame at the front of your 5th wheel (typically in the front storage area).
Attached are some photos pointing out the weld stops and the mounting instructions for the Ground Control 3.0 for your reference.
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Lippert Ground Control 3.0 Electric 5th Wheel RV Leveling System w Touchpad - 4-Point Set
- Camper Jacks
- 5th Wheel Camper
- Stabilizer Jacks
- Steel
- 10001 lbs or More
- Electric Jack
- 36 Inch Lift
- Bolt-On
- 4 Jacks
- Lippert
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Replacement Weld-On 5th Wheel Landing Gear Leg Bracket for Lippert RVs
- Shop: Replacement Front Jack for Lippert Ground Control 3.0 Leveling System
- Search Results: roof
- Search Results: patch kit rv roof repair
- Search Results: weld on bracket
- Shop: Camco RV Vinyl Trim Insert - White - 100' Long x 1" Wide
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Video: How To Choose Camper Leaf Springs
- Q&A: Looking for Replacement Thermostat for Coleman Mach RV AC Unit
- Search Results: trailer hitch
- Shop: Trailer Wiring
- Search Results: trailer tires and wheels
- Shop: Redarc Tow-Pro Liberty Brake Controller w/ Universal Wiring Harness - Dash Knob - Proportional
- Search Results: trailer jack
- Shop: MORryde X-Factor Crossmember for Standard Frame Hangers
- Shop: Brake Controller
- Shop: Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Search Results: trailer leaf springs
- Q&A: Does etrailer Carry Andersen Ultimate Safety Chain Attachment
- Q&A: Ultra Fab Electric Landing Gear Replacement for 2006 Keystone Raptor 3319
- Q&A: Where are Circuit Breakers/Fuses Installed on Lippert Electric Stabilizer Jacks
- Q&A: Replacement Front Jack for Lippert Ground Control 3.0 Leveling Systems
- Q&A: Can I Grease or Lube the Inside of My Lippert 3.0 landing Gear?
- Q&A: Replacement Front Jack for Lippert Ground Control 3.0 Leveling Systems
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: What is a Fifth-Wheel Camper
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Wiring Diagrams
Jerred H.
1/19/2026
Hey Vince, how did things go with the Ground Control 3.0 jacks and the existing brackets on your trailer? Your update could make it easier for the next person setting up the same system.