Do You Have a Bearing Kit For 1-1/6" Diameter Spindle with a 1.25" Grease Seal Landing?
Updated 02/03/2026 | Published 07/19/2024 >
Products Featured in This Question
Question:
Good morning. Do you have a bearing kit for 1-1/16” hubs. In er and outer bearings are both the same. Also does the kit include grease seal? I will need a 1.25” ID Thanks for your help
asked by: Grant D
Expert Reply:
You are going to need 2 of the Bearings # L44649, 2 Races # L44610 and a Grease Seal # 34823 for each hub. You will also need either a Cotter Pin # 165649 or EZ Lube Tang Washer # 5-101 if you are unable to reuse your current fasteners. Our Bearing Kit # BK1-150 which comes with the L44649 bearings has a larger 1.5" ID Seal # 10-9.
Product Page this Question was Asked From
Replacement Bearing Kit with Bearings L44649, Races L44610, Seal 10-9 - Fits 1.063" Spindles
- Trailer Bearings Races Seals Caps
- Bearings
- Bearing Kits
- Standard Bearings
- Bearing L44649
- Race L44610
- 1000 lbs Axle
- 2000 lbs Axle
- 2200 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Replacement Grease Seal for a 168255TC Rubber Coated Seal
- Q&A: How to Select Replacement Hub with Bearings, Races and Seals
- Q&A: Is There a Replacement Spindle For a Dexter D44, 4400LB Trailer Axle?
- Article: Most Popular Wheel Bearings
- Q&A: Do You Have Hubs and Brakes Compatible with Dayton Fayette 9349 Axles from 1979 Travel Trailer?
- Q&A: Solution for 1978 Prowler Travel Trailer with Bad Trailer Magnets
- Q&A: Which is Better for Highway Use 4.80-12 or 5.30-12 Trailer TIres
- Q&A: Troubleshooting Trailer Tire Wear on the Outside Edge of the Tire
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers


Jameson C.
2/3/2026
Hey, how did the bearings and 1.25" grease seals work out for your hubs? Your update could make it easier for the next person matching parts for the same size setup.