Need To Replace Titan 225 Caliper From Titan 4843100 Disc Brake Kit  

From my research the hub and rotor assembly you're looking for is for a 3,500 pound axle with a 5 on 4-1/2 bolt pattern. It uses bearings #L68149 and #L44649 and has a Dacromet finish for marine use. If the bearing numbers match you can use…

The caliper for the Titan Disc Brake Assembly #T10HREKITBB will sit partly over the rotor with the piston-side towards the inside of your trailer with the mounting bracket on the spindle-side of the spindle brake-mounting bracket. I have attached…

Some trailers are equipped with EZ Lube spindles, which have a grease fitting or zerk in the end of the spindle, and a small hole in the spindle that lets grease enter the interior of the hub and reach the bearings. This allows grease to be added to…

The DeeMaxx 10" Hub/Rotor Assembly #DE49VR is only compatible with the DeeMaxx brand calipers like part #DE86VR. If you have Kodiak 225 calipers you will need a Kodiak brand rotor as well, such as part #KHR10D.

We do not have a Kodiak disc brake caliper cross reference to automotive calipers but for the brake pads there are cross referenced parts. If you refer to the linked image you'll see a partial list of cross-compatibility of brake shoes for GM…

Finding information on the Tie Down 46250 was not an easy task as it was discontinued awhile back. From what I could find, it looks like the calipers marked 46250 often times have to change the mounting bracket and rotor/hub in addition to the…

To determine the size of the brake assemblies you need you have to measure the depth and width of the hub drum on the axle like what you see in the picture I attached. The most common size is 2-1/4 inch wide like the #T4071600-500 that you…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

There really isn't a particular maximum trailer weight that is used to determine when brakes need to be added to both axles of a tandem axle setup. While I do still recommend checking your local laws, I am also not aware of any general laws that…

Traditionally, trailer manufacturers did not use electric brakes on boat trailers because the brake magnet wiring and trailer wiring did not always have the best insulation or water protection. These days, more and more manufacturers are using…

In order to verify the spindle dimensions so that you can pick out the correct hub/drum you have to get exact dimensions. For that you need to use a digital caliper like part #PTW80157. For how old your trailer is this is especially important as the…