Breaking Down the D Washer for EZ Lube Spindles Video

I do not see an extension kit for the Demco Hydraulic Brake Line Kit for Single Axle Trailers #DM5426. However, you can just step up to the Demco Hydraulic Brake Line Kit #DM5643 which has the additional main line (long run) length that you are…

The Dexter "8-248" is a hub assembly for 3,500 lb axles that uses an L68149 inner bearing and a L44649 outer bearing. This hub assembly was offered in both 5 on 4-1/2" and 5 on 4-3/4" bolt patterns therefore you would need to…

Grease seal set #RG06-050 is what you will need. These are double lip seals, just like what you have (the spring indicates that) and the dimensions are all the same including the 1/2 inch width.

The Timken Bearing Kits #TMK54ZR and #TMK34ZR both come with the Timken #L44643 bearings, #L44610 race, 204507 seal and cotter pin. The only difference is that the #TMK34ZR comes with a grease cap, while the #TMK54ZR does not. Other than that, they…

Excellent question, and the difference between the two kits comes down to the dimensions of the equalizers. What you will want to do is match up the size of your equalizer with the size of the equalizer in these kits. - 6" Long, 4" Tall…

Thanks for the pictures! Based on the weight of your 2008 Keystone Cougar 5th Wheel, you will want the item #LG-1 landing gear set. You are going to want to measure to be sure this is the right size for you. The two things you will want to measure…

Since you need 10 inch by 2-1/4 inch hydraulic brake assemblies that have a 4 bolt pattern that is 2-7/8 inches the drum brake kit part #AKUBRK-35-D would be what you'd need. The bolt pattern you mentioned is the standard 4 bolt pattern.

To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…

90-120 ft lbs of torque is probably about right for your trailer rims. If you check out the lug nut torque chart that I attached you will see that nearly all of the torque specs are that and higher.

There are many ways you can secure wires to a trailer. I would not recommend the use of tape as it will wear out quickly when exposed to the elements. Soldering is also not recommended because it is a more permanent method and you may need to change…

There really should be a flat washer between the outer bearing of your hub and the nut that holds it on. The washer protects the back side of the bearing from the edges and points on the back side of the spindle nut. The Washer For 1 inch Spindle,…

A replacement tang-style spindle washer like part #5-101 is intended to be installed behind the castle nut and have its prongs bent down so that they prevent the castle nut from rotating on an E-Z Lube type spindle. The castle nut holds the washer in…