Adapter To Convert Separate Brake/Turn Signal Wires On 7-way Round To Combined Brake/Turn Signal
Updated 05/31/2024 | Published 05/27/2024
Products Featured in This Question
Question:
Hello, We have a International 4300 that had two truck 7 pin round trailer connectors on it. I am trying to wire in a 7 pin flat connector. The truck does not seem to use a brake light signal that uses the turn signals. It has a separate wire for brake lights. Is there a convertor available? Thanks
asked by: Andrew H
Expert Reply:
Hey Andrew,
You are correct, a 7-way round does not use combined turn signals and brake signals, they use a dedicated brake signal wire. You can use a 3 to 2 converter # RM-732 to combine your three wire system to a 2 wire system that a standard RV 7-way connector needs.
Product Page this Question was Asked From
etrailer Rubber Hitch Cover for 2" Trailer Hitches - Qty 1
- Hitch Covers
- Misc Covers
- Plain
- Rubber
- Fits 2 Inch Hitch
- Standard
- Square
- etrailer
more information >
Continue Researching
- Q&A: Stealth Hitch that Fits 2024 Ford Mustang Mach-E
- Q&A: Why Does the etrailer Trailer Hitch part # e72AR Have a Higher Towing Capacity than the Vehicle?
- Q&A: Best Replacement For Older Dometic Duo Therm 57915.531 Ducted Single Zone AC System With Furnace
- Q&A: Does Roadmaster Invisibrake System Require Installing Diodes too
- Q&A: Replacement Air Conditioner for a Dometic Duo Therm 600315.331
- Q&A: Recommended Replacement AC for a Dometic 57915541
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Air Conditioner 13,500 BTU Will Replace My Current Dometic Air Conditioner?
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class