Dimensions Of The Brophy Rope D-Ring Tie-Down Anchor # BR59FR

Question

Question:

What are the dimensions of this tie down? Both the exterior and actual d ring.

asked by: Greg

0

Expert Reply:

Hey Greg,

I've drawn up a diagram of the dimensions for the Brophy Rope D-Ring Tie-Down Anchor # BR59FR and attached it below. If you have any other questions then just let me know.

expert reply by: Kevin C

0

BR59FR Dimensions
(click to enlarge)

Answer 1

Hi Wayne, I went out to the warehouse and measured the Caliber D-Ring Anchor Kit part #CA89VT for you. The plate dimensions are 4" long by 3 3/4" wide and the inner diameter of the ring is 1 1/4" and outer diameter is 2 1/4". What…

view full answer...

Answer 2

Hey Dave, thanks for reaching out! The Erickson Round D-Ring Tie-Down Anchor #EM59110 has a capacity of 1,200 lbs and is not going to be strong enough to cinch down your Polaris RZR securely. You need the CargoSmart Anti-Rattle D-Ring Tie-Down Anchor…

view full answer...

Answer 3

Hey Jordan! Yes, the Global Link Vise Lock #295-000024, Global Link RV Entry Door Locking Latch #295-000019, and Replacement Cam Lock Cylinder #295-000005 can all use the same key. Just make sure you choose the keyed alike option for each one before…

view full answer...

Answer 4

There is not a bike rack that will fit a spare tire that loads the bike vertically as you stated without an adapter. The Softride Hang 2 #SR27041 is the closest to what I think you are looking for, but you would need to add an extension like #C45795…

view full answer...

Answer 5

My technical contact at Global Link advised that for their locks like #295-000021 that you referenced which use a flat key they do not offer a tube-type re-keying kit. We do have tubular key lock replacement parts from Camco, such as #CAM44303 and…

view full answer...

Answer 6

The cylinders for the latches need to be measured for length to get you the correct replacements. This means removing the lock cylinder which should not be difficult if it is able to be removed as some are and some are not. If you disassemble the…

view full answer...

Answer 7

On the Global Link Vise Lock #295-000024 the single bottom screw (just below the lock cylinder) is protected from corrosion by a press-in plastic cap. I went to our warehouse to check this item myself. This cap is best removed by prying it off with a…

view full answer...

Answer 8

Thank you for the photo. We may have a few replacement seal options for your Seal on 2001 SnoPro Clamshell Enclosed Trailer but you'll need to confirm the dimensions we have will work for what you're needing. The Rubber Large Half Round Seal…

view full answer...

Dimensions Of The Brophy Rope D-Ring Tie-Down Anchor # BR59FR

Product Page this Question was Asked From

Continue Researching