Will The Porch Light For a 1986 Avion RV Require The Ground To Attach to Metal Body?

Question

Question:

porch light is going on 1986 avion rv. metal body. will it need metal base for ground. thanks

asked by: Rick J

0

Expert Reply:

A Porch Light # OPT24WR for your 1986 Avion Azur is not going to ground from the base on the light to the body on your chassis. Therefore you are not going to have to have a metal base for it to ground. The Porch Light # OPT24WR you found would be a good candidate as it has a separate power and ground wire which you can run to a suitable ground location.

expert reply by: Bud M

0

Answer 1

The light output of the Command Porch Light part #328-007-60WE is 560 Lumens. It also only draws .21 of an amp! I attached a review video link for this for you to check out as well.

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 5

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 6

Hey Jairo. So we do not offer a direct replacement for the Norcold N611, but we do have a good replacement option for you. It really comes down to what will fit in your cutout space. Take a look at the Norcold RV Refrigerator w/ Freezer - 8.2 cu ft -…

view full answer...

Answer 7

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Answer 8

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 9

Hello Bruce, Thanks for writing in! Using butyl tape between the trailer body and the Single Axle Jeep Style Trailer Fender - Diamond Plate Aluminum - 13" to 15" #HP96VR is exactly the route I would go. It stays flexible, creates an…

view full answer...

Answer 10

Yes, The Furrion Chill HE #FR62PV will be a direct replacement for your 15K BTU Coleman with a heat pump, just keep in mind you'll be losing that feature as this unit does not have a heat pump.

view full answer...

Will The Porch Light For a 1986 Avion RV Require The Ground To Attach to Metal Body?

Continue Researching