Replacement Installation Kits For Bull Bar On a 2013 Nissan Frontier

Question

Question:

Im looking for bull bar install kits for a 2013 Nissan frontier

asked by: Rob T

0

Expert Reply:

We have the Replacement Install Kit # AA36FB for the Black # AAB35-9002 or Stainless # AA35-9002 Aries Bull Bar which fits your 2013 Nissan Frontier. We also have the Replacement Install Kit # 32-169PK for the Westin Ultimate Bull Bar # 32-1695.

expert reply by: Bud M

0

Answer 1

I spoke with my contact at Westin, who tells me that the Bull Bars are somewhat vehicle-specific. The only Bull Bar that is compatible with the 2010 Frontier is the #32-1695 in black powder coated steel. The hardware kit is part #32-169PK, and is…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 4

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 5

Since wire color codes are NOT universal, we always recommend wiring by function, rather than wire color. If you look at the Trailer Wiring FAQ article I have linked you to, you can see some diagrams showing the proper way to wire a vehicle and…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Replacement Installation Kits For Bull Bar On a 2013 Nissan Frontier

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching