Replacement Tonneau Cover for a 2008 GMC Sierra 1500 w/ a 6-1/2' Bed and a TruXedo Lo Pro

Question

Question:

I have a 2008 gmc serria 1500 box is 6'7"long the sticker on the front on my mounting frame says 1703866 I can tell from the videos it's a lo pro please advise

asked by: jeffrey

0

Expert Reply:

It sounds like you have the TruXedo Lo Pro Soft Roll-up Tonneau Cover item # TX571101 on your 2008 GMC Sierra 1500. You'll need the Replacement Tarp for TruXedo Lo Pro Soft Tonneau Cover item # TX571101-CVR if that's what you're wanting to replace.

expert reply by: Jerred H

0

Answer 1

If your original Fulton jack is a snap-ring type swivel jack that uses the same 2.313-inch pilot hole diameter then Fulton 1200-lb jack #FTJ120W0301 should do the trick. You may not even need to bother with welding on the (included) new mounting…

view full answer...

Answer 2

For a replacement jack I recommend the Fulton Bolt-Thru Swivel Marine Jack #FXPD15L. This has a 1,500 lb lift capacity and the dual wheels you're looking for. The jack has a bolt-on installation and fits frames up to 3" x 5". The Z-Max…

view full answer...

Answer 3

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 4

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 5

Hey Doug! The Firestone Ride-Rite Air Helper Springs #F35FV are the right kit for your 2026 Ford F-350 FX4 dually. However, you will need to measure to be sure it fits. The distance from the top of your rear axle to the top of the jounce bump stop…

view full answer...

Answer 6

If you check out the attached picture you can see where you'll find the serial number and date code on your cover.

view full answer...

Answer 7

The best method to identify the tonneau cover on your 2008 GMC Sierra will be to look for the date code and or serial number. The serial number is located on the driver's side of the front header on the TruXport frame. The date code is printed on…

view full answer...

Answer 8

The Curt E16 5th Wheel Hitch w R16 Roller for Chevy/GMC Towing Prep Package - Slide Bar Jaw - 16,000lbs item #C16667 will drop right into your OEM puck system and has an adjustable height of 15-1/4 - 18-1/4 inches. This will allow you to leave your…

view full answer...

Answer 9

Could you get me pictures of your tonneau cover so that I can identify it possibly? And which exact seals do you need?

view full answer...

Answer 10

I reached out to my contact at TruXedo and she did say that the numbers you found on your tonneau cover refers to the TruXedo Lo Pro QT #TX571101. As you mentioned this particular cover isn't technically a fit for your 2004 GMC Sierra (it fits…

view full answer...

Answer 11

Thanks for that info, and we do have the 1117929 replacement tarp, which is for the TruXedo Lo Pro Soft Roll-up Tonneau Cover #TX571101 that fits certain model year Chevy Silverado trucks with a 6-1/2 foot bed. The correct part number for that tarp…

view full answer...

Answer 12

B&W gooseneck hitch balls such as part #BWGNXA2010 feature a square shank that fits into the square opening of a B&W gooseneck hitch such as #BWGNRK1309. Curt gooseneck balls use a round shank and the two types are not compatible. No adapters…

view full answer...

Replacement Tonneau Cover for a 2008 GMC Sierra 1500 w/ a 6-1/2' Bed and a TruXedo Lo Pro

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching