Picking Out Gooseneck to Fifth Wheel Adapter that Could Fit Diamond C FMAX 212 HDT Trailer
Updated 01/22/2024 | Published 01/21/2024
Products Featured in This Question
Question:
Gooseneck to King Pin Hitch adaptor. Which hitch adaptor would work on a Diamond C FMAX 212 HDT trailer ?
asked by: Jim F
Helpful Expert Reply:
Most likely the Ram Gooseneck to 5th wheel adapter part # KPG5-R30IP is what you'd need as this fits most gooseneck hitch tubes that have an inner tube diameter that is 4 inches. If you have a different setup let me know. Another popular setup is 4 inch square tube like with the part # KPG5-Q25-IP.
I attached a link to a page that has all of the adapters we have for you to check out as well.
Product Page this Question was Asked From
Gooseneck to 5th Wheel Trailer Coupler Adapter - Round - 30K
- 5th Wheel Gooseneck Adapter
- Adapts Trailer
- Gooseneck Trailer to 5th Wheel Hitch
- No Extra Clearance
- 30000 lbs
- Replaces Inner Tube
- Not Shock Absorbing
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Is There a Replacement Spindle For a Dexter D44, 4400LB Trailer Axle?
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Wiring Instructions for the Tradesman Vaquero Hydraulic A-Frame Trailer Jack
- Q&A: Correct B&W Companion Hitch Base For 2024 Chevy Silverado 2500 Short Bed With Factory Puck System
- Q&A: Dimensions of the Ram Gooseneck to 5th Wheel Trailer Coupler Adapter
- Q&A: Solution for 1978 Prowler Travel Trailer with Bad Trailer Magnets
- Q&A: Do You Have Hubs and Brakes Compatible with Dayton Fayette 9349 Axles from 1979 Travel Trailer?
- Article: Adapters for Towing a 5th Wheel Trailer with a Gooseneck Hitch
- Article: Best 5th Wheel to Gooseneck Adapters (2023)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Double-Eye Trailer Suspension System Review
- Article: Brake Controller Installation: Starting from Scratch