Convection RV Microwave to Replace Apollo AAC24B1B

Question

Question:

my Apollo AAC24B1B died. You recommended a Greystone 324-00105. It is a straight M/W. Is there a M/W convection combo oven that will fit in the same space I have?

asked by: Robert C

0

Expert Reply:

The High Pointe RV Convection Microwave part # HP99ZR is close enough to the dimensions of your Apollo that it would fit and work great as a replacement. It has dimensions of 20-1/2" wide x 14-3/4" tall x 18-11/16" deep.

expert reply by: Jameson C

0

Answer 1

The Greystone Built-in Microwave with Trim Kit part #324-000105 is the best replacement option for an Apollo Microwave AAC24BIB in regards to size. The Greystone Built-in Microwave measures 23-3/8" wide x 15" tall with the trim kit…

view full answer...

Answer 2

I looked up the dimensions of your Apollo AAC24BIB and found it to be 29-7/8W x 16-7/8T x 18-3/16D Inch so our best matching microwave replacement would be the part #FMCM15SS which has rear vent option like you need as well.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 8

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 11

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 12

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Convection RV Microwave to Replace Apollo AAC24B1B

Products Featured in This Question

Continue Researching