Which Base Rails Are Needed For Thule TracRac SR Ladder Rack On a 2018 Ford F-350 Long Bed?

Question

Question:

Hi, Im looking for bed rails for a 2018 Ford F-350 Long Bed 8-0 +/-. Can you please guide me as to which model of bedrails I would need for this vehicle. Thanks

asked by: Jim M

0

Expert Reply:

Your 2018 Ford F-350 long bed will need the Base Rails # TH21000 for the Thule TracRac SR Sliding Truck Bed Ladder Rack # TH43003XT.

expert reply by: Bud M

0

Answer 1

Hello Dave, Yes, the Thule TracRac SR Sliding Truck Bed Ladder Rack - 1,250 lbs #TH43003XT-000 fits both the 2020 Ford F-350 and the F-450. This would be a great fit for your 2020 F-450 Crew Cab 4WD Dually. I attached an install video to help with…

view full answer...

Answer 2

Yes, Thule does have a sliding SR TracRac that fits your 2019 F-450 long bed with the part #TH43003XT-000 I just checked with them to confirm. Then for a roll up tonneau you'd need the BAK Revolver #BAK49ZR and you'd be set. This is only…

view full answer...

Answer 3

To know if your 2017 Ford F-350 has an in-bed puck system installed you'll just need to look and see if you have four rounded attachment points (usually covered up when not in use, like in the attached picture). If you don't see these in your…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Jonathon thank you so much for all of that additional information! To haul your bikes behind your class C Sprinter motorhome, while flat towing your Mini, I recommend the Hollywood Racks RV Rider Bike Rack item #HLY64FR and the Roadmaster Dual…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 10

Hey Kelvin, welcome back. To flat tow a 2026 Ford Maverick with your Demco Commander II Tow Bar item #DM9511012, I recommend the following parts: Baseplate Kit - Demco Tabless Base Plate Kit item #DM38CV Wiring Harness - Roadmaster Diode 7-Wire to…

view full answer...

Answer 11

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Which Base Rails Are Needed For Thule TracRac SR Ladder Rack On a 2018 Ford F-350 Long Bed?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching