Can I Use The etrailer Enclosed Trailer Transition Plate e32JR For Loading A 2,000 lb Pallet?

Question

Question:

Enclosed Trailer Transition Plate - Universal - 1,000 lbs To whom it may concern, I need a transition plate that can handle a 2000 pound pallet. What do you recommend?

asked by: Roderick P

0

Expert Reply:

The etrailer Enclosed Trailer Transition Plate # e32JR is the only transition plate we carry and it does have a working load limit of 1,000 lbs. We have tested this transition plate extensively, and have found that it holds up well, even when loading items well over 1,000 lbs. We did find that the plate will bend when under heavier loads. So while it may technically work for loading a 2,000 lb pallet, it is not recommended to exceed the 1,000 lb WLL, as this may cause non-warranty damage to the plate itself, and possibly your trailer.

expert reply by: Jesse M

0

Answer 1

The etrailer Enclosed Trailer Transition Plate #e32JR is 15" long and the width can be adjusted from 48" to 102" using the included hardware and mounting holes.

view full answer...

Answer 2

Here is a list of the tools needed to install the etrailer Enclosed Trailer Transition Plate #e32JR: - Tape Measure - Drill - Hex Drive Socket Adapter - 10mm Socket - 13mm Socket I have also added a link below to the instructions of the #e32JR for…

view full answer...

Answer 3

The etrailer Enclosed Trailer Transition Plate #e32JR will work very well for loading and unloading motorcycles. It has a working load limit of 1,000 lbs so even with your 850 lb bike, you are well within parameters weight capacity wise. Especially…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 8

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 9

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 10

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 11

The #84 spindle is just a common way to identify the spindle dimensions typically used for 3,500 lb axles. So instead of listing out the parts, people can just say they have #84 spindles and it's easier to know what fits it. The CE Smith Trailer…

view full answer...

Answer 12

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Can I Use The etrailer Enclosed Trailer Transition Plate e32JR For Loading A 2,000 lb Pallet?

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching