Minimum Flow Rate fora Fogati Tankless Water Heater

Question

Question:

I am trying to get an unused Fofatti instantaneous water heater to work in a friends camper van. Power seems to be connected correctly but I have yet to run the multi meter over it. My concern at the moment is with water flow. What should the flow be in LPM. The unit was installed in the camper van before he purchased it and does not appear to have been used.

asked by: Geoff U

0

Expert Reply:

The Fogatti RV Tankless Water Heater # LSB64FR has a minimum flow rate of 0.5 gal/min and can operate on a minimum of 14.5 PSI, however it's recommended to have 40 to 45 PSI for the best performance.

expert reply by: Bryce D

0

Answer 1

I went ahead and consulted the owner's manual for your Furrion RV Tankless Water Heater - Gas - Automatic Pilot #FR68SR, and this symptom is correlating with there could be lime scale forming due to precipitation of hard water. To fix this,…

view full answer...

Answer 2

Our installers and customer experiences have led us to believe that the Furrion tankless heaters like the part #FR98SR are by far the best and most reliable so that is what I would recommend. Not saying that the Fogatti is a piece of junk but the…

view full answer...

Answer 3

The reason your Fogatti RV Tankless Water Heater #LSB64FR is not staying on may be due the unit not getting electricity, gas, and water. Or, it may also be due to a dirty filter. Ensure the filter has no debris in it, and if there is clean or replace…

view full answer...

Answer 4

Hey Max! It does sound like you need a 15"x15" hot water heater. The closest option I have with a 18" x 18" door is going to be the Fogatti InstaShower 7 RV Tankless Water Heater item #FG46FR. This one is designed to replace a 10…

view full answer...

Answer 5

I recommend going with the Furrion RV Tankless Water Heater #FR98SR over the Fogatti RV Tankless Water Heater #LSB64FR because it has a higher heating capacity (up to 60,000 Btu as opposed to the Fogatti 41,800 Btu) and it comes with a 2 year…

view full answer...

Answer 6

Good question, Robert. There are indeed a few differences between all 3 of the Fogatti tankless water heaters and I have them listed out below: Fogatti InstaShower 7 Tankless Water Heater - 48,000 Btu #FG37FR -Lower Btu rating which is better for a…

view full answer...

Answer 7

When we installed the Fogatti Tankless RV water heater part #LSB44FR we did use butyl tape like the #AL28FJ to seal it all up. You can see the entire process in the attached install video on this page.

view full answer...

Answer 8

Basically the MaxxAir Replacement Shroud for Coleman-Mach #MA8335A5261 and the MaxxAir TuffMaxx #MA00-325001 fit the same Coleman Mach AC units but are two different styles of cover. I like the two piece part #MA8335A5261 better as it will be a bit…

view full answer...

Answer 9

The MaxxAir Replacement RV Air Conditioner Cover - Coleman-Mach / RVP Brand RV Air Conditioners - White #MA8335A5261 is the replacement I recommend for you and it has a simple installation. It will fit your Coleman AC unit.

view full answer...

Answer 10

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Minimum Flow Rate fora Fogati Tankless Water Heater

Continue Researching