What Would Cause Trailer Brakes to Not Work Well After Trailer Sat for a Long Time
Published 10/25/2023
Question:
I dont use my trailer for almost a year. Then when I do use it, I have to drive many miles until the brakes start working again. Is this rust on the ball, clam shell, brake plate? And what can I do to avoid this? Thank you.
asked by: Richard B
Expert Reply:
It is most likely the drum of your hubs basically getting the rust worn off if anything. I wouldn't say this is a typical issue though. If it was anything to do with the wiring or electrical side your brake controller would show that it wasn't connected during the time it wasn't working.
I would think that inspecting the brake assemblies and drums would lead you to what would need to be addressed.
Product Page this Question was Asked From
Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 6000 lbs
- Brake Assembly
- Manual Adjust
- 12 x 2 Inch Drum
- Dexter
more information >
Continue Researching
- Q&A: Converting Trailer from Surge Brakes to Electric Brakes
- Q&A: Hardware for etrailer Electric Trailer Brakes - 12" - Left/Right Hand Assemblies
- Q&A: Recommended Bearing Kit for a Dexter 5,200 lbs Axle PN 57920
- Q&A: Why Doesn't Dexter Suspension Upgrade Kit come with 6 Bushings
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Electric Brakes for a Dexter Axle on a Gooseneck Trailer PR-FF-SEC-FF 6KPR-GGSEC-66
- Q&A: Troubleshooting A Brake Buddy Stealth Braking System That Activates When Not Flat Towing
- Q&A: How to Adjust Self-Adjusting Trailer Brakes
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: Trailer Brakes Not Working? Troubleshooting Guide
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Article: 7 Common Questions Everyone Has About Trailer Tires