Replacement Hanger Kit For a 10,000LB Tandem Axle Tilt Trailer With 2" and 5-1/2" Hanger Heights  

It is not uncommon for the trailer hangers on a tandem axle trailer to be all the same size or for there to be different sizes that can be 1-1/2 to 2 inches different in height when you compare the center hanger to the front and rear. For example,…

Suspension hangers like what come with the Hanger Kit part #APT3HD that you referenced are designed to be welded to the trailer. You would not want to bolt this kit to the frame of your trailer.

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

It sounds like you want a diagram of the wiring for your trailer and breakaway system. I am attaching an article with pictures about wiring trailers. I am also attaching an article with pictures on wiring a breakaway kit. I also recommend making the…

The brake wire providing voltage is wired in parallel, with one lead from each magnet being grounded to the trailer frame. We have a great Wiring Help Page that shows a diagram, I will provide a link to it below.

No, it does not matter which wire from the magnet is attached to power or ground. Just make sure one wire is properly grounded and the other wire is attached to the electric brake output circuit from the trailer connector. I have linked a video that…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

Actually, the P3 now has the upgraded axis accelerometer like the P2. The Tekonsha P3 Trailer Brake Controller #90195, will work with both electric over hydraulic brakes on the trailer as well as electric brakes. It has a menu option on the display…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…