Why are Trailer Center Hangers of Tandem Axle Hanger Kits Longer
Updated 05/19/2015 | Published 05/18/2015 >
Question:
i am building a car/utility trailer, what is the purpose of longer hangers for equalizer , and what hanger set would give me maximum suspension travel.
asked by: Mike G
Helpful Expert Reply:
The longer hangers are the center hangers. The reason they are longer than the end hangers is because the shackle straps of the equalizer. It is somewhat hard to explain, but the longer center hanger is to compensate for how the shackle straps move the spring up higher.
Check out the picture I attached for more info. Hopefully that explains it better.
Leaf springs typically can only travel a few inches. So you won't gain much travel by going with longer hangers.
Product Page this Question was Asked From
Tandem-Axle Trailer Hanger Kit for Double-Eye Springs - 2-1/2" Front/Rear, 5-7/16" Center
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Tandem Axle
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Search Results: dump trailer
- Search Results: hydraulic fluid fuel transfer pump
- Search Results: hydraulic oil fuel transfer pump
- Shop: Tandem-Axle Trailer Hanger Kit for Double-Eye Springs - 2-1/2" Front/Rear, 4-1/4" Center
- Video: 4-Leaf Double-Eye Spring for 4,000-lb Trailer Axles Spec Review
- Article: Where to Position the Trailer Axle?
- Shop: Replacement Power Unit for etrailer and Ram Hydraulic Trailer Jacks and Scissor Hoist Systems
- Search Results: trailer leaf springs
- Shop: 5-Leaf Double-Eye Spring for 6,000-lb Trailer Axles - 25-3/8" Long
- Article: Double-Eye Trailer Suspension System Review
- Article: Slipper Spring Trailer Suspension System Review
- Q&A: Hanger Distance for Installing 25-1/2 inch Leaf Springs with Hanger Kit # APT8
- Q&A: How to Determine Hanger Spacing on Tandem Axle Trailer
- Q&A: Installation of Hanger Brackets and Springs for Tandem Trailer Axles
- Shop: Tandem-Axle Trailer Hanger Kit for Double-Eye Springs - 2-1/2" Front/Rear, 5-7/16" Center
- Shop: Center Hanger for Double-Eye Springs - 5-7/16" Tall - 3/4" Bolt Hole
- Shop: Front/Center/Rear Hanger for Double-Eye Springs - 4-1/4" Tall - 9/16" Bolt Hole
- Shop: Tandem-Axle Trailer Hanger Kit for Double-Eye Springs - 2-1/2" Front/Rear/Center
- Q&A: Dimensions of Center Hanger in Redline Tandem-Axle Trailer Hanger Kit for Double-Eye Springs APT8
- Q&A: Why is Center Hanger Longer for Tandem Axle Trailer Hanger Kit
- Q&A: Replacement Hanger Kit For a 10,000LB Tandem Axle Tilt Trailer With 2" and 5-1/2" Hanger Heights
- Q&A: Hanger Placement on the Tandem HAnger Kit part # APT8



