Compatible Wheel For A Lippert Quick Drop Tongue Jack # LC733926

Question

Question:

Can I use a wheel with this jack instead of the included footpad?

asked by: Bob G

0

Expert Reply:

I tested a few wheels that we have in stock and found that the # JC-102 would physically fit on the Lippert Quick Drop Tongue Jack # LC733926, but would limit your capacity down to wheel's at 1,200lbs.

expert reply by: Kevin C

0

Answer 1

You can see all of our available jack caster wheel assemblies on the linked page. These fit on a 2-inch-diameter jack tube, such as #BD500245. If you can find a brand name or part number on your jack that will help to narrow down the correct parts,…

view full answer...

Answer 2

The 3" bolt hole spacing is the standard pattern for mounting bolt holes on most trailers. The Lippert Quick Drop Tongue Jack #LC733926 that you are looking at will match that same pattern. Do note that the holes on the jack are oblong to…

view full answer...

Answer 3

In either position the handle of the Lippert Quick Drop Tongue Jack #LC733926 would not spin and lower on it's own. There's enough friction in the screw of the jack to prevent vibration from causing it to turn on it's own.

view full answer...

Answer 4

The Ram Removable Caster Assembly, #JC-101, is a swiveling caster when attached to the jack. The caster assembly uses a nylon bushing at the swivel point between the connected mounting tube and the wheel assembly.

view full answer...

Answer 5

The vast majority of trailer jack wheels don't use traditional steel ball bearings as they aren't really meant for rotation speed but rather weight bearings. I am not aware of any options which use traditional steel ball bearings. The…

view full answer...

Answer 6

Hi Roger, I checked with Lippert, and sadly a gear is not an available replacement part for the Lippert Quick Drop Tongue Jack #LC733926. The only replaceable parts are the mounting hardware and footpad so the best I can offer is to replace it with a…

view full answer...

Answer 7

To add a wheel with the Round A-Frame Trailer Jack #TJA-5000S-B all you need is the wheel caster #JC-101. I would recommend supporting the tongue of the trailer with a floor jack before taking apart anything internal of the jack.

view full answer...

Answer 8

Gary, I find the Ark Xtreme Off-Road Swivel Trailer Jack #ORJW350D is one of the best jacks for using the wheel to move a trailer around. It has a dual wheel setup which also makes it easier on loose surfaces such as gravel and grass. This jack will…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 11

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Compatible Wheel For A Lippert Quick Drop Tongue Jack # LC733926

Products Featured in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching