Longest Square Bar that Can Fit Thule Feet for Square Bars

Question

Question:

I have an rv with tracks on the roof. I had the thule square load bar - steel - 96. They were damaged. I have everything but the load bars. Is there another load bar that is 96inch or another system that can go in the thule tracks that will work? They have to have a length of 96inch in length. Just looking for a solution. Thanks for your help!

asked by: Josh

0

Expert Reply:

The longest load bars we have that will fit the older style of Thule square bar feet is 79 inches with the Inno # IN436L.

expert reply by: Jameson C

0

Answer 1

Hey Jet, thanks for reaching out. Let me start by asking you this; what kind of Thule square bars do you have? Are they the new style square bars with a bottom channel? Or are they the old style bars with no bottom channel where the bar inserts thru…

view full answer...

Answer 2

The minimum crossbar spread to use the Thule Hullavator Pro Kayak Roof Rack and Lift Assist w/ Tie-Downs #TH898 is 24" apart. You can however space your crossbars up to 36" should you need to, but 24" is the minimum for safe use.

view full answer...

Answer 3

I spoke to my contact at Thule about your older Hullavator and she informed me that the struts aren't available separately. The ONLY way to address your problem would be to go with the Replacement Arm Assembly #TH753352303 that you referenced.

view full answer...

Answer 4

As far as the Thule Hullavator #TH898, it will attach to most styles of Yakima crossbars (for example, the JetStream crossbars #Y00425, the Round Bars #Y00409, and the CoreBars #Y00422). However, you need additional components to mount Yakima…

view full answer...

Answer 5

Your 2013 Volvo XC70 has the Thule square bars which use Thule Evo Raised Rail Feet #TH710401. There is a pre-cut hole with a circular cover, you will need to remove the cover which will allow you to install lock cores #TH450400. I attached a…

view full answer...

Answer 6

To remove or install the Railing Foot #753-2157-02 from the cross bar you need to push in the gray latch and slide down the black cover identified by the red arrow in the picture attached. This will allow you access to the allen head bolt to loosen…

view full answer...

Answer 7

Hi Timothy; yes, the Inno Square Crossbars #IN436L will fit the old Thule Tracker II feet, as the Inno and Thule square crossbars are the same size.

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

Hey Bryan, that's a good question. The pricing can definitely be misleading, but I wouldn't use it to judge the quality of the tire. A lot of that comes down to promotions, inventory, and whether you're looking at a tire by itself or…

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Longest Square Bar that Can Fit Thule Feet for Square Bars

Product Page this Question was Asked From

Continue Researching