Replacement Boat Winch For Fulton T1801 Unable To Get Replacement Parts For

Question

Question:

I am in need of a ratchet repair kit for my Fulton T1801 trailer winch for my boat but not sure which one to get.

asked by: Rodney K

0

Expert Reply:

I recommend replacing your Fulton T1801 boat trailer winch with the Dutton-Lainson Hand Winch # DL17042. Fulton was acquired by First Brands in the beginning of 2023 and has had issues with manufacturing of parts including those for your Fulton winch. Because of this most replacement parts for older items are no longer being developed and it is unclear what will happen with several parts. Switching to the Dutton-Lainson will help ensure you can get support for the winch.

expert reply by: Bud M

0

Answer 1

To get the cable to come off of the Dutton-Lainson Worm Gear Hand Winch, item #DL10974, you would need to crank the winch until the cable is all the way unwound from the winch drum and then continue cranking in the same direction until the cable is…

view full answer...

Answer 2

The bolt hole dimensions on the bottom of the Jif Marine Single-Speed Boat Trailer Winch with 20' Strap and Brake item #315-W2000D are 2.5 inches apart center to center. The attachment point to the center bolt is a slot that is 3.5 inches - 5…

view full answer...

Answer 3

Fulton makes high quality winches like the Fulton Winch #F142201 that you referenced. JIF Marine makes great winches too and the Single-Speed Boat Trailer Winch #315-W2000D is almost an identical design except for it comes with a 20 foot cable and a…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

According to Blue Ox, it'll take an experienced installer about 4 to 5 hours to complete the installation of their #BX1128 Base Plate Kit on a 2016 Jeep Grand Cherokee. The install isn't what I'd call super-difficult, but the installation…

view full answer...

Answer 9

Hi Paul, you’re definitely on the right track here, and I can help you narrow this down with confidence. With your tandem 3,500 lb Dexter axles and 33 inch spacing, both the Dexter EZ Flex part #K71-652-00 and the Lippert Road Armor part #LC53CK are…

view full answer...

Answer 10

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 11

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 12

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Replacement Boat Winch For Fulton T1801 Unable To Get Replacement Parts For

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching